Regarding types of projects in Heat transfer in Energy systems.
If it's possible can it be done with some alloy? Which type of alloys can be opted?
02 March 2014 7,914 2 View
Entropy is defined relatively with temperature and enthalpy of the system but what type of characteristic is entropy?
01 February 2014 9,998 10 View
Since it has better yield strength than steel, less vonmises stresses when compared ..
11 December 2013 1,945 4 View
Please suggest any simple procedure to measure it.
11 December 2013 9,361 4 View
Since it plays the main role in manufacturing of automobile parts.
11 December 2013 4,025 4 View
Since the former one is used for exhaust gases where as the later one is used for injecting fresh charge. How can both be implemented. If implemented what is the effect on the engine efficiency....
10 November 2013 6,700 10 View
The power stroke in internal combustion engine gives power at high temperatures and pressures, but there is shortage for fuel necessities.
10 November 2013 6,249 2 View
Since it runs on electrically charged battery, is it economically preferable?
10 November 2013 6,388 2 View
The knocking effect is less, compared to conventional engines; and first order vibrations are zero, compared to the conventional engines of same number of cylinders, light weight, high power...
09 October 2013 2,420 0 View
Since the maximum temperature attained by the working fluid in reciprocating engines will be sustained for a fraction of time, is there any chance of implementing boilers, heat exchangers for...
09 October 2013 9,124 2 View
Could you recommend some articles on Urban Transportation System optimization and Innovation?
13 August 2024 2,595 3 View
How to develop investments in renewable energy sources?
08 August 2024 5,112 3 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,537 1 View
Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...
31 July 2024 5,785 4 View
Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...
30 July 2024 9,824 2 View
My screen printed electrode CV is given here. For Nerstean one electron reaction the delta E value should be close to 57 mV and ration of Ic/Ia should be close to 1. I did CV of my screen printed...
30 July 2024 4,671 3 View
After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?
29 July 2024 4,955 0 View