I just want to find out if modelling the flow for two non-reacting gases CFD in ANSYS would be accurate since the software does not seem to include this combination.
How else can this be modelled? Any other software available to model these components
CFX or Fluent?
Quite simple, add materials (gases) on the material list, then in the boundary (inlet) add how much of each species
All other answers and suggestions are still welcome.
Actually, Nicholas i would first be modelling with Fluent and will try with CFX as well.
Hi Joseph,
You already have a good supposition by opting for fluent instead of ANSYS. For fluid flow modelling I learnt that, Fluent is a little bit preferable.
Eric, ANSYS has within it FLUENT and CFX.So basically, the modelling is to be done with ANSYS. Thanks
- Badges
- Science topic