Calculation of odd ratio and relative risk in a study?

More Yehya Elkhawly's questions See All

I want to simulate 3d transient thermal storage (Cubic block of concrete with a hollow cyl contains hot stream), what is the best Ansys solver used ?

Thermal Transient or Fluent! I have tried to use transient thermal but the results show that there is no Temperature Gradient in the flow direction. So how can I let the flow temperature change...

01 November 2021 3,819 3 View

What is the maximum limit of corrosion depth or mass loss in a metal that corrodes in a given environment?

Hello, I have a question about atmospheric corrosion of metals. A metal (steel, zinc, copper ...) corrodes more or less quickly depending on the corrosiveness of the environment. The metal loses...

12 January 2021 7,942 4 View

How to estimate the deposition rate of sulphur dioxide and chlorides ?

Hello, I am looking for an atmospheric dispersion model of chloride and sulphate ions that allows to estimate the deposition rate of sulphur dioxide and chlorides (mg / m^2. Day ) for a given...

15 October 2020 4,607 0 View

How to define the chloride penetration in concrete with respect to the wind and the distance from the coast ?

In order to estimate the degradation rate of reinforced concrete structures in a marine area, I am looking for a model to estimate the dispersion of chloride ions in the atmosphere by taking into...

08 September 2020 8,209 5 View

Can any one explain the difference between vibration modes and assignments in infrared analyses?

When I read this short paragraph, ''- Vibration modes was in Greek letters for stretching and bending vibrations etc; Use amide I, II and III identifications. - Assignments like...

29 August 2020 3,316 5 View

There is a difference between Nitrogen level of chitin determined by, Kjeldahl method, CHNS elemental analysis and EDX elmental analysis?

Extracted chitin was subjected to Kjeldahl method, the result of nitrogen level obtained was 1.7 % ; however, EDX elemental analysis present various values of nitrogen form 3 to 6 %. How can we...

20 August 2020 9,086 5 View

What are the equation and conversion factor to estimate protein content from mushroom?

Total nitrogen was calculated with Kjeldahl method, I found different equations and factors ''Total nitrogen content of shrimp waste was determined using the Kjeldahl method. Separately, pure...

17 August 2020 4,814 9 View

Consultation on the bleaching step during the isolation of chitin?

Can any one describe a suitable conditions and solvent to isolate pigments from fungi chitin? I used ethanol,chloroforme/methanol/water..no result obtained I get white powder with the solution...

02 March 2020 653 2 View

Is Journal of Medical – Clinical Research & Reviews a predatory journal?

I have received an acceptance for publication my article in the "journal of medical -clinical research &reviews" I am not sure if this is a predatory journal and if no what the impact factor...

27 May 2019 5,949 15 View

Looking for a university or research institution in Europe, North America or the gulf to host seminars/course, on the impact of politics on urbanism?

I am looking for a university or a research institution in the field of urbanism and city planning that is interested in hosting and funding a series of seminars that are related to the impacts of...

23 December 2017 227 4 View

Why 3 replicates for most biological assays? Is it enough to examine the data fits normal distribution?

Just bounced on me. Before statistically analysing significant difference, shouldn't we see if data fits normal distribution first? Is 3 replicates enough to testify the hypothesis of normal...

31 July 2024 8,141 13 View

How do we pick data for determination of Validation Acceptance Criteria?

Hello, colleagues! There is commenting open for new upcoming edition of USP 1033. Validation target acceptance criteria is now different from what it used to be and it doesn't include Cpm....

23 July 2024 7,292 3 View

On the website RevMan, can I use OR already without raw data ?

I am conducting a systematic review and have an observational study. I want to perform some meta-analyses using the already calculated odds ratios. Can I use RevMan for this purpose? If not, do...

21 July 2024 4,110 4 View

The large odds ratio and the wide confidence interval, what are the potential reasons for these findings? Is this result reliable?

In my study, I found an odds ratio (OR) of 65 with a 95% confidence interval (CI) ranging from 1.2 to 195. Given the large odds ratio and the wide confidence interval, what are the potential...

07 June 2024 402 3 View

What are the answers to Epidemiology Question including revalence, case fatality etc ?

Suppose that in January 1996, 1000 adult residents of a community accepted an invitation to be examined for hypothyroidism at a local clinic. Eight persons were found to have the disease, it was...

27 May 2024 6,947 7 View

How to conduct/interpret power analysis for binary GLMM within-subjects with 2x3 independent factors?

Dear community, I can't seem to find any clear information on power analyses work so I'm throwing my question out onto the internet hoping for answers. :) Study Details I am doing a...

19 May 2024 9,214 4 View

How build Forest plot in STATA?

(STATA) Hello everybody. I would like to build a Forest Plot graph that includes all this information from the table. I am unable to build the commands to include this information in the chart....

11 May 2024 6,944 6 View

Kolmogorov-Smirnov test using ordered quantitative data. Can you help me?

Assuming this is my hypothetical data set (attached figure), in which the thickness of a structure was evaluated in the defined positions (1-3) in 2 groups (control and treated). I emphasize that...

09 May 2024 871 4 View

Methods to calculate Shannon Index?

I have three field margin types (grassy/shrubby/tree) and each type have 5 sites. I need to calculate Shannon index for insect counts from each field margin type.... Q1. In my case how should I...

19 April 2024 681 6 View

Can anyone help me with the STATA db metatrim function?

When I try to do the metatrim on STATA I get the following error: db metatrim . metatrim _ES _seES, reffect eform Note: default data input format (theta, se_theta) assumed. subcommand meta...

28 March 2024 9,326 2 View

Joe Stanek

https://www.medcalc.org/calc/odds_ratio.php

Pretty simple calculator for both OR and RR here.

Eddie-Williams Owiredu

You may also find these links and PDFs useful. Find below

https://www.statisticshowto.datasciencecentral.com/odds-ratio/

https://www.openanesthesia.org/odds_ratio_calculation/

Yuqing Xue

You may consult the classic book "An Introduction to Categorical Data Analysis" by Alan Agresti. A fundamentally useful book, if not necessary.

Md. Shaddam Hossain Bagmar

I would recommend you to read Chapter 4: Measures of Disease-Exposure Association, of the book "Statistics for Epidemiology" by Nicholas P. Jewell.

Link:

https://www.amazon.ca/Statistics-Epidemiology-Nicholas-P-Jewell/dp/1584884339

If you want I can share the pdf file with you.

Jason Leung

Supercourse is always my choice to find lecture notes of epidemiology and biostatistics. There are many powerpoints with detail description.

https://www.pitt.edu/~super1/

please search by entering your keywords (e.g. relative risk/ odds ratio) in right top corner and you will get many useful PPT