07 July 2020 1 8K Report

I am starting to build a ferromagnetic resonance system for thin magnetic films. Any leads on where I could start?

More Sabieh Anwar's questions See All
When I am trying to distill triethyl amine while drying it over calcium hydride. How do I design the setup to let hydrogen escape without losing NEt3?

I am new to research. The boiling point of triethyl amine (NEt3) is 89 degrees centigrade. I am skeptical that when I will let the hydrogen escape which is getting generated in situ, I will also...

21 July 2024 7,284 4 View

How to extract the embedded GPS data from a video created from a GoPro camera?

What is the best 'free of charge' software for extracting GPS data from a video created from a GoPro camera? I have checked the Telemetry Extractor...

02 June 2024 3,138 2 View

How to modify a metaheuristic algorithm to obtain a better-performing algorithm?

How to modify a metaheuristic algorithm to obtain a better-performing algorithm?

28 April 2024 3,627 4 View

What is the effects of elovera on the efficiency of transplantes human endothelial cells?

effects of elovera on the efficiency of transplanted endothelial cells

28 December 2023 1,994 0 View

Drivers and software for LIRA-300 Laser Raman Spectrometer?

We are trying to revive an old Raman Spectrometer from Lambda Scientific. This is a LIRA-300. I was wondering if someone had the drivers and the software of this now obsolete system. In...

04 November 2023 5,129 0 View

How do I run a mediation with two independent variables and one dependent variable in PLS SEM? Please suggest some paper as well its interpretation ?

How do I run a mediation with two independent variables and one dependent variable in PLS SEM? Please suggest some paper as well its interpretation ?

28 October 2023 3,857 1 View

Immunohistochemistry of MMP-2 and MMP-9?

Immunohistochemistry of MMP-2 and MMP-9 expression in dibetic wound healimg

24 October 2023 2,449 1 View

Does hyperglycemia caused by infection stress affects the severity of pneumonia in non diabetic peoples?

Elder population, infants, and pregnant women are at the risk of ICU admission leading to deàth. In such cases, it is neccessary to recognise the role of accidental hyperglycemia linked with...

03 January 2023 5,982 2 View

How long should I wait after submitting for a minor revision?

Greeting Respected RG Scientist and Researcher I submitted a minor revision for my paper based on the comments by the editor and Reviewers 1 and 2. in Hindawi publisher. It has been over two...

31 December 2022 1,626 15 View

I need a cost effective methodology for the production of biochar by slow pyrolysis method at 200-300 degrees C for 1h and 2h??

hello everyone I need an inexpensive methodology for the production of biochar from sugarcane bagasse by adopting slow pyrolysis techniques with temperatures 200 and 300 degrees C with residence...

11 November 2022 119 5 View

Similar questions and discussions
How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

What is single absorption ESR spectroscopy ?

In the context of Electron Spin Resonance (ESR) spectroscopy, under what conditions is an absorption spectrum considered to be a single absorption spectrum?

25 July 2024 2,325 1 View

Why electrical charge on the moving plate increase?

Hi, everyone This figure depicts a simulation of an electrostatic energy harvesting system in COMSOL Multiphysics software. My question is regarding the relationship between the changes in...

19 July 2024 4,694 4 View

How Can I Resolve a Persistent Unwanted NMR Peak at 1.25 ppm?

Hello everyone, I am facing a consistent issue in my NMR spectra with an unwanted peak appearing at 1.25 ppm. This peak seems to vary with the amount of sample: it becomes more pronounced with...

15 July 2024 9,065 4 View

Is VSM measurment of NdFeB alloy powder sample require any spesific sample preparation ?

Is any specific sample preparation required to perform VSM measurement of NdFeB alloy powder to get a square-shaped M-H loop? Or is it mandatory to make magnetically aligned and sintered pellets...

09 July 2024 1,969 0 View

What are the criteria that must be retained for the development and validation of a qualitative NMR method ?

Dear Community, I would like to develop and validate a qualitative NMR method for the analysis of a specific category of chemicals, and my question is the following: What are the criteria that I...

08 July 2024 1,402 4 View

How to conduct the NMR study of a nano-composite film?

Solid state NMR study

03 July 2024 422 1 View

I have NMR,Mass spec,IR and uv of a mixture of three unknown compounds from natural products.I am attaching the data who can help me elucidate?

I isolated a mixture of three compounds from the stem bark of a plant . I have NMR, Mass spec, IR, and UV data. There are a lot of things I can't make meaning out of. Kindly help me with the...

02 July 2024 9,531 4 View

Problem Justifcation of below research topic?

Analyzing the effectiveness of apply the Extended Producer Responsibility (EPR) concept for reducing pre-consumer apparel waste within a Star Fashion Pvt Ltd apparel company.

30 June 2024 3,764 0 View

COMSOL simulation of transient wave optics propagation is not physical?

Hi guys, I am trying to simulate a 1 ps long plane wave propagating in a dispersive material, with the wave optics transient module. According to the drude-lorentz model, when the frequency of...

29 June 2024 486 1 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close