Greetings to all !! What do you think about the 3D printing masks for the COVID 19 pandemic? . The micropore problem indicates to me that it can be solved with an acetone coating. They would be homologated to the N95 ??. Would it be useful to add an activated carbon filter? Thanks for your comments!!
Łukasz Szarpak
we can print everything, the question is what filter will be fitted?
0 votes
0 thanks
Muhammad Yousuf
On searching 3- D masks, these masks are not used for protection from COVID-19 but are used in make-up, plastic surgery and fashion, as I could find out from the links below:
1. https://www.instructables.com/id/Make-a-3D-Printed-Mask-from-Photos/
2. http://www.avsarsurgical.com/3d-mask
3. https://www.3dhubs.com/talk/t/3d-face-mask-from-photo/1927
0 votes
0 thanks
More Nicolas Saa's questions See All
Similar questions and discussions