I need a large model say 100 x100 m with a mesh size of 0.05m. such a large model cannot be made in version 7. before upgrading to version 8, I need to confirm whether it is working in version 8 or not?
I have also tried trail version 8. it is also not working
if anyone has version 8, I can send you a file to check.
Thanks
I'm afraid I can't answer the question specific to FLAC version 8, but here are some related points which hopefully will help;
The trial versions of FLAC are mesh size limited, so would not give you an indication of the maximum mesh size.
For a full software version; you may want to double-check that you are running a 64bit version of the software on a 64 bit computer. After that there may be other hardware (specific computer set-up) limiting factors, in addition to any software limits, such as available memory.
Thanks, Damian Morrow you are right, the trial version has a limitation of the mesh size.
Dear Alireza Rashiddel, Please check your inbox, I have sent you file a week ago. please have a check
Dear Jawad
Did you increase the memory used by FLAC?
You can increase it by right click on FLAC icon->properties
Then in the ((shortcut)) tab, at the written section in front of ((Target:)), change the ((128 giic)) to ((256 giic)). Please aware that in some computers, if you input a larger value than 256 (like 512), your FLAC will not be loaded.
Majid Jazebi Yes I have already increased in properties, but not working,
- Badges
- Science topic