xxxx
Why are you asking the same thing again?
By the way bronze melts at ~950°C, are you sure it will hold 10 bar at 800°C.
I am sorry for asking it again, its an error from my side
I would like to heat a steel tube inside a hollow cylindrical water cooled copper tube using induction heating coil but I am concerned about the power consumption. How can I know how much power...
07 August 2018 8,605 1 View
Is there a Gasket or O Ring material that can withstand temperature up to 800°C and pressure up to 10bar?
05 June 2018 5,472 2 View
xxxxx
05 June 2018 5,181 4 View
At what distance I can place metals parts on upper and lower position of vertically placed induction heating coil (50mm outer diameter and 100mm long) in order to not let the outside metals heat...
05 June 2018 9,608 1 View
What are the Nusselt number(Nu) correlations that I can use for free convection of gases in cylindrical tube with transient flow?
07 August 2017 7,053 2 View
How can I calculate the distance to maintain between induction heating coil and metal parts outside the coil in order to protect them from magnetic field? Is there any formula to calculate the...
07 August 2017 9,275 2 View
can anyone suggest me some online or offline sources where I can find all material properties of all ceramics in one place?
06 July 2017 10,203 3 View
Hello all, can anyone suggest me an insulating material which should act as electrical and thermal insulator at the temperatures 1200°C or above and should not react with oxygen.
01 January 1970 4,673 7 View
what are the Nusselt number(Nu) correlations for natural convection of gas through vertical hollow cylinder with transient flow through cylinder?
01 January 1970 6,985 4 View
Hello experts, Does anyone know any free software about retention index prediction ?
08 August 2024 7,403 2 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...
06 August 2024 4,953 0 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 980 5 View
There are anaerobic gas pak jars and environment providers in the laboratory that provide anaerobic environmental conditions for the growth of anaerobic bacteria. However, there is no anaerobic...
05 August 2024 4,945 3 View
or we can collaborate
01 August 2024 6,705 2 View
I am working on algal extract to which gas chromatography (Not GC-MS) spectrum I want to discover. My question is can we identify specific compounds using retention time if I compared the RT with...
29 July 2024 8,034 4 View
List down the various factors responsible and how does this effect the overall biogas production when it is related to Hydraulic retention time of the digester based on the feedstock?
27 July 2024 4,800 4 View
Why methanol and sulphuric acid, used in the analysis of polyhydroxyalkanoates (PHA) methyl esters by GC-MS? Additionally, why do we typically use non-polar solvents in GC-MS?
22 July 2024 1,210 2 View