Hello everybody! I am new with workshop fluent and try to model Laminar pipe flow.
I used under xy-plane Sketch 1 and rectangle with H=20 m, V=5.
There arise problems with Base 0bject Sketch1, I tried first to define Operation: Frozen, Orient: No, Thickness 0.1 m. But the Base 0bject =Sketch1 did not work for the order Surfaces from Edges.
Could you help with this problem? Thank you. Regards
Peter
Hi, Peter:
FLUENT recognizes a simulation domain as fluid. Keeping it in mind, any solid objects in the domain will be treated as boundaries.
The following steps will work for your question:
Next, go to Mesh (in the Project Schematic). Over there, you can define material property, meshing, and name/define surfaces or edges just simply placing your mouse censor at those to be defined and right click your mouse to click Select Named Selection to name it. Please be aware that you must select point/edge/surface/body from the toolbar before proceeding the named selection.
I hope that it will help you.
- Badges
- Science topic