Dear All,
Hope you are doing well.
How to draw a line in center of the artery fluid volume domain. The problem is that, the line/plane couldn't fall properly at center of artery. When i use the option "LINE command from Location in ANSYS Fluent post processor.
The geometry or model was extracted from patient CT scan data so which is not in a single plane.
Thanking you in anticipation.
&
Regards,
Dear Abdul Gaphur ,
From the yellow line it is clear that you have used z axis correctly. Now coming to x-y co-ordinates, you need to manually adjust by reducing x and increasing y by a slight amount. It's a bit hit and trial until you reach the centre of the artery.
If it doesn't work in Post processing, I would advise you to use add line/plane from Fluent. The benefit of FLUENT is that you can see the plane moving realtime.
Faheem Ejaz add line/plane?? Yes, i used same to draw above shown yellow line but my question is about exact center of fluid volume or at mid of axis i want to draw a line. I know ur options , those are also not workout.\ Thanks
Regards,
- Badges
- Science topic