7 Questions 28 Answers 0 Followers
Questions related from Tomas Sabaliauskas
We need to push a large load (2 tones) using two stepper motors, connected rigidly to the axis (two screws). I'm worried the motors could micro-step out of sync. And cause malfunction. I can see...
22 October 2020 6,533 4 View
We're making something special for the lab. We need a 4m long linear rail, that can push 27kN at 20mm/s speed. Two NEMA 42 motors with a screw could deliver the performance. It's hard to find a...
12 October 2020 905 4 View
I'm working in geotechnics. We are testing "fatigue" response of cyclic loaded sand, where deformation cycles (or strain cycles) of constant amplitude are applied. I need references to research...
23 May 2018 4,003 2 View
Even ultra low vacuum grease evaporates near absolute vacuum. Cavitation takes place when pressure drops near absolute zero pressure, near -100 kPa, -1 atm... when the "vapor pressure" limit is...
23 January 2018 4,071 6 View
Asked 3 minutes ago I have a problem. Measurements show the opposite of what convention assumes. It occurred in geotechnics, but could affect all material modelling branches. I tested soil...
01 January 1970 4,877 3 View
I am trying to make a sand model, which captures liquefaction / post-liquefaction recovery around a structure. We have the laboratory results and measurements, but to use them a model stable at...
01 January 1970 917 3 View
I have a problem. Measurements show the opposite of what convention assumes. I test soil specimens. We try to decode how much deformation a certain loading (force) sequence will generate. After...
01 January 1970 5,188 4 View