13 Questions 23 Answers 0 Followers
Questions related from Sayed A Banitabaei
I'm using VOF in Fluent to simulate impact of a falling droplet onto a solid particle in mid-air (pls see the picture). Instead of using a constant contact angle (CA), I want to apply a dynamic CA...
10 October 2017 1,519 2 View
Hi there, Center of Gravity Location is a parameter accessible in the 'Dynamic Mesh Zones' window inside the Fluent. I'd like to know what's the command to get "center of gravity location" in a...
10 October 2017 1,705 1 View
Using VOF ith a laminar model, I'm simulating collision of a droplet and a spherical particle. The particle moves very fast (~7 m/s) and so penetrates into the falling droplet and deforms it to a...
05 May 2017 7,558 3 View
In a droplet impact onto a stationary particle, I want to calculate mass conservation of VOF method (before impact vs. after impact ends). For that, I use Reports => Volume Integrals window. In...
03 March 2017 5,312 7 View
I'm simulating droplet impact onto a moving particle (axisymmetric VOF+6DOF in dynamic mesh). I tried to increase the particle mass in UDF by a factor of 1000 (for the same particle size). But, as...
01 January 2017 6,365 7 View
For simulating a droplet collision onto a moving particle, I use a semi-circle as my particle in an axisymmetric solution. However, I don't have just one line as the 'axis' of domain and particle...
01 January 2017 9,137 6 View
I want to do an axisymmetric simulation of a head-on collision between a falling droplet and a spherical particle. However, as you can see in the attached figure, dynamic mesh fails to follow the...
01 January 2017 5,535 11 View
For simulating a droplet and particle collision, I assigned particle mass using 6DOF below and I defined particle velocity with 'Centre of Gravity Velocity' in 'dynamic mesh' window. As figure...
12 December 2016 8,114 8 View
I'm simulating a particle collision onto a droplet in Fluent (attached Fig.). Particle is defined as a 'wall' and when I'm using 'Dynamic Mesh' with 'C.G. Vel= -6', the simulation runs well....
12 December 2016 4,451 0 View
I have a particle and a droplet both of them are moving to collide together. Therefore, I need to assign a mass to the particle as momentum of impact matters very much. I'm using a UDF for...
12 December 2016 3,643 3 View
I'm simulating collision of a droplet and a moving particle in mid-air. The particle is launched towards the droplet while the drop is moving in opposite direction (pls. see Fig. 1)For solving...
11 November 2016 9,297 3 View
11 November 2016 9,311 3 View
As you may know, wettability is a characteristic of each surface which determines what the contact angle would be when a droplet is put on the surface (see here for more info). Surface roughness...
01 January 1970 6,495 8 View
