Samarth Jain

8 Questions 4 Answers 0 Followers

Questions related from Samarth Jain

Can anyone tell me how can I rotate a 3D turbine using SDOF solver in ANSYS FLUENT?

I have tried everything I knew in FLUENT but I still could not rotate a very simple turbine (mesh attached below) I created in fluent using SDOF solver with inlet velocity 10 m/s. Can anyone...

17 September 2017 8,089 1 View

How can I get a variable as output paramter from A UDF for post processing in fluent?

I have defined a SDOF solver UDF for a body in which it's Moment of inertia changes with every time step. Now I want to capture this MOI at every time step and use it in post processing to make a...

14 September 2017 2,882 4 View

Why do we need to create a cell zone around a void to apply SDOF solver in ANSYS FLUENT?

Why do we need a additional cell zone around the body (void) on which we want to apply SDOF solver in FLUENT. Why cant we just create a negative volume of that body in the fluid domain and apply...

13 September 2017 5,427 3 View

How do you create a named selection of void space in ANSYS fluent?

I have a box and inside the box I have a ball shaped shell, I want to create a named slection of the empty space inside the shell. How can I select it as the empty space does not appear in the parts.

06 September 2017 8,654 3 View

Changing moment of inertia at every time step in six DOF solver in ANSYS?

I want to change moment of inertia of the an object in six DOF solver at every time step using a relation? is it possible in ANSYS CFX/FLUENT? Does six DOF solver consider each time step or does...

03 September 2017 1,375 1 View

Can you use 6 dof solver for 3d geometry in ANSYS fluent?

I want to rotate a 3D turbine depending upon the forces acting on it because of free stream air velocity. is it possible?

02 September 2017 727 3 View

Create a path along the bent beam to drill a hole through it?

I have a bent square beam. I want ansys to create a path for drilling a hole along the entire length of bended beam (whilst keeping the hole in centre of the beam along its entire length). is it...

29 August 2017 1,524 2 View

Wind turbine with continuously changing blade pitch angle ?

I want to run a flow simulation on a wind turbine in Ansys CFX .The wind turbine has to maintain a constant rpm and for that the blade pitch needs to change simultaneously as the incoming wind...

29 August 2017 7,156 3 View