Ravi Kumar

5 Questions 7 Answers 0 Followers

Questions related from Ravi Kumar

How can i generate a separation bubble using upper countour wall. What are the Design steps?

I want to create a separation bubble over a flat plate using a contour wall as show in the figure. I want to create a separation bubble around 0.4 m from the leading edge of plate. My plate length...

23 October 2020 7,408 5 View

Need help in designing a countour which create a seperation bubble on a flat plate ?

Hi This is Ravi. i am trying to create a separation bubble on a flat plate using a contoured upper wall. I want to apply same pressure distribution of a given blade on the flat plate. I have read...

22 October 2020 6,837 5 View

How can i extract data along a curved plane in Tecplot 360 EX?

Hello All, I am working on a cambered 3D airfoil and i have run a case in Fluent. Now, i need to extract some data alont a curved plane/surface just offset of suction surface. The curved surface...

28 February 2020 5,648 2 View

Why interface curve between two surfaces splits in two curves when doing Build topology in ICEM?

Hello, I am trying two make hybrid meshing over a 2D turbine blade. For that i have made geometry in designmodler with two split surfaces at interface around the blade. But when i am importing it...

04 January 2020 8,396 3 View

Why I am getting a warning during hybrid initialization it says " Convergence tolerance of 10^-6 is not reached during hybrid initialization" ?

Hello Friends, I am trying to simulate a 3D LPT blade using hybrid meshing in fluent. I made the mesh by merging two meshes in ICEM. The mesh around the blade is made using blocking and other is...

11 September 2019 4,980 5 View