Mohd Suhairil Meon

10 Questions 10 Answers 0 Followers

Questions related from Mohd Suhairil Meon

Explicit bolt load in ABAQUS?

Anybody know how to apply bolt load using thermal contraction force? i want to apply it for explicit analysis in Abaqus Explicit. Where to apply thermal coefficient,temperature change? Thanks in...

04 April 2017 2,959 4 View

How to model an open hole non-crimp fabrics (NCF) composite using abaqus?

Do we need to have special software like TexGen?. Can anybody suggest good references to build this model especially to create the stitching part. I read some atricles, mainly focussing on RVE...

07 July 2016 3,792 1 View

How to properly model contact related to bolted single lap joint in abaqus?

I have tried for each contact pair with surface-surface, finite sliding and with friction coefficient. However, the composite plates somehow penetrate the bolt. Master-slave concept used here...

05 May 2016 8,845 0 View

Can anybody advise me on how to get material parameters for hashin Damage analysis as well as Evolution law?

I will conduct several tensile testing for CFRP lap joint with rivet. However, since I also need to validate it using numerical approach, I was thinking to use hashin Damage model for finite...

11 November 2014 1,136 4 View

Does anybody know about a self-piercing rivet in Abaqus?

Dear all, Anybody know about self-piercing rivet in Abaqus? Can anyone share any tutorials or good references in terms of implementation that process in Abaqus? I am planning to do self riveting...

11 November 2014 1,555 3 View

How can I model Hashin composite damage in ABAQUS?

I am currently modelling a riveted lap joint CFRP. I have a problem regarding the implement damage model (Hashin) since my material model uses a solid element. Can anybody advise me of any...

10 October 2014 4,582 18 View

Which is better for a beginner in FE: ncode or fe-safe in fatigue evaluation?

I don´t have any idea about these two add on softwares for fatigue calculation. I am also new in FE simulation. Any comments or suggestions about the operating of these two softwares.

03 March 2014 3,583 4 View

How can we model fatigue in ABAQUS? How can I create amplitude?

I have read many things about this, but could not find any tutorial on fatigue simulation for example fatigue simulation of round specimen (dog bone) under constant amplitude loading, and need to...

03 March 2014 7,161 6 View

What is the best way to apply displacement control in ABAQUS?

I have conducted a tension test with displacement controlled rate of 1mm/min. In ABAQUS, where should I put this value? or do I need to make reference point constrain?

03 March 2014 5,082 5 View

How can I get a damage parameter?

I want to simulate tensile until fracture. for elastic I input E and v, and for plastic I used true stress and plastic strain value calculated from the stress-strain diagram after elastic until...

03 March 2014 9,617 11 View