Amira Nabil

10 Questions 8 Answers 0 Followers

Questions related from Amira Nabil

How to include a material in DateX?

I made a simulation of NWTFET with trap-assisted tunneling. After I added the trap-assist tunneling in the interface material InAs/Al2O3, the error appeared. I defined the parameters of AL2O3...

18 March 2023 8,675 0 View

How to compare a simulated 2D structure with Experimental 3D results of GAA TFET?

I want to compare a GAA TFET Experimental results of Id-Vgs that is normalized to the diameter with a 2D simulation results that is normalized to 1 um. Should I divide the simulated resulted by...

02 January 2023 5,952 4 View

How to include a parameter file in Sentaurus?

I want to include a material Al3O2 to my simulation using Sdevice. I put parameter file of Al3O2 in the path of my simulation and I wrote in parameter file: Material="Al3O2" { #includeext...

28 October 2022 7,179 2 View

How to model X-ray source using sdevice Sentaurus TCAD?

I would like to simulate the electrical response of nanowire ﬁeld eﬀect transistors that exposed to nano-focused hard X-rays using Sentaurus TCAD tool. How can I model the X-ray source?

27 August 2021 7,039 3 View

How could I solve the convergence problem using Sentaurus sdevice?

I want to simulate a mixed mode using Sentaurus sdevice but unfortunately I faced a convergence problem. I tried to do the following: 1. Change the meshing 2. Change digits 3.Change liner solver...

09 April 2020 2,620 0 View

What models are used in Sprocess to simulate mobility degradation after annealing step?

I want to simulate mobility change in doped silicon due to stress generated after an annealing step using Sprocess Sentaurus TCAD. What model should I use to save mobility degradation during...

11 November 2019 1,626 1 View

How to model an interface trap of TFET using Sdevice ?

I am trying to model interface traps of TFET using Sdevice sentaurus tool. I build the strucutre using structure editor and then I used sdevice to simulate the current. But the results have some...

30 September 2019 2,423 2 View

How could I include an interface in Sdevice simulation of traps??

I am trying to simulate traps in TFET interfaces between oxide and silicon using sentaurus Sdevice. I included the traps in command file as follow: Physics (MaterialInterface = "Silicon/HfO2")...

17 September 2019 9,322 3 View

How to specify a valid electron barriertunneling mass in sdevice parameter file??

I'm trying to simulate TFET and I specify the nonlocal meshes, Barriertunnling modelsand traps model for regions and interfaces. Then I specify the parameter of tunneling in the parameter file as...

27 August 2019 5,151 7 View

What models can I use to simulate quantum TFET using sentaurus TCAD?

I'm using Sdevice to simulate Quantum TFET and I used the following models eQuantumPotential hQuantumPotential Hydrodynamic( hTemperature ) Mobility (Enormal(Lombardi)...

30 July 2018 718 7 View