16 Questions 38 Answers 0 Followers
Questions related from Ajit Behera
There are several types of powder bed fusion processes that exist in additive manufacturing. Currently, What is the updated model of the powder bed fusion technique ?
13 May 2021 2,666 0 View
What is the Difference between Bulk Metallic Glass (BMG) and High Entropy Alloy (HEA) with respect to a specific parameters (no. of elements, Purity of constituting elements etc.). Also,...
12 December 2018 9,039 7 View
Just neglect VPS for minimizing the cost.
10 August 2017 8,846 2 View
I have done annealing of P20 steel at 1000 degree C. Again we follow cryo-treatment at different temperature. we found the result are: decrease in hardness and increase in impact resistant. What...
12 January 2017 2,711 3 View
There is a complex structured braphite block. We want to modify the surface properties with higher mechanical strength. Your suggestion is highly appreciable. Thank You.
17 February 2016 9,971 6 View
Suppose we are depositing NiTi on Si substrate by magnetron sputtering. Give me different type of process, How I can make a freestanding film from that constraint film. When I am going to etch the...
25 April 2015 6,606 2 View
Hello everyone, I am trying to set up a "nondestructive testing lab" for casting metal. Please suggest any nondestructive testing equipment. If possible, then send me the supplier address. Thank You.
22 January 2015 3,763 9 View
Equilibrium cooling or non-equilibrium cooling? What are the conditions for formation of dendritic structure?
27 November 2014 6,146 12 View
In my manuscript, one of the reviewer comment: "XRD indexing is wrong in below figure"? i used :α=Ni, β=Ti, π=Si, ϒ=NiTi, λ=NiTi2, η=Ni3Ti, ζ=Ni3Ti4, φ=Ni4Ti3, χ=Ni2Si, o=TiSi2, τ=Ni3Ti2Si,...
27 November 2014 1,785 14 View
Which software is better for "Monte-Carlo simulation" to find out the number of Sputtering species ? Can i use "SRIM-TRIM", Crystal ball software or any other ? Please suggest me for better...
04 November 2014 873 17 View
We have a material of magnesium oxide-85% in which porosity is 30%. We want to deposit some pure MgO on its surface to decrease the porosity. Is it possible? if so, then what should be the...
15 October 2014 7,439 3 View
Please suggest me the application of Ni-Ti thin film in naval industries. Thank You.
10 September 2014 9,182 2 View
Suggest me the procedure to calculate the number of species during sputtering inside the plasma. That is, to measure the number of atom strike on the target and the number of atom ejects from the...
01 August 2014 7,233 10 View
If we will fabricate 49Ni-51Ti and want to train the product to actuate at 40C , then how we will follow the procedure in 3D printing?
01 January 1970 1,808 4 View
SMC can operates above 650 degree celcious and retain SME. SMA with its variety of intermetallics will retain its integrity to show SME.
01 January 1970 6,111 0 View
Very minute amount of Ni-release happening during biocompatibility test of Ni49.5Ti50.5 . How we can obstruct the Ni-release without compromising with the NiTi smart properties. Any treatment or...
01 January 1970 6,221 0 View