you can select in the input section ( mass flow rate)

Hello!

I am attaching two PDF for modelling with ANSYS. I hope they will be useful for you.

Thank you Mohammed

Hello Sergii

Not yet; but I think you can integrate your velocity distribution with respect to height into Ansys Fluent by means of a UDF function.

                          :-)

I wish you the success in your project

Great work. 

It can be solved using a UDF to  change the velocity over height. i can help in this point as i have a good experience in Fluent UDF.

Hello Mohamed. yes please if you can.

so please can you give some information about your  case model and data that help me?

you can select in the input section ( mass flow rate)

in this case, you have to a required domain and your body

for modeling, you select your body like wind turbine rotor, car body, plane etc..

then you have to create a flow around this body or system it's known as domain

this complete form of combination you just discrete in a small element 

and that part is known as meshing.

and the apply boundary condition of your real problem

run this case in fluent with the diffrent boundary condition

witch gives clear picture e of flow after analysis in fluent witch is your results