Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

How to classify strictly upper triangular matrices by similarity?

Let F be a field. Consider U, the set of n times n strictly upper triangular matrices in F. For X, Y in U, we call them similar if there exists some S, which is non-degenerate and upper...

01 March 2021 2,957 8 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

Can anyone please help me in processing SAR SLC data to generate interferogram using SNAP?

I have two scenes of the study area, one top and the other bottom. As per the tutorials and papers published, the step include coregistering the master sand slave images. However, when i try to...

24 February 2021 6,372 1 View

Satellite orbit estimation using Recurrent Neural Network - what should I use?

Hello, I am a master's student studying in Yonsei Univeristy, Korea. I am trying to estimate the state of satellite, using Neural Network. Below is a simple flow of my study. 1. Train (t0 ~ t1)...

23 February 2021 6,383 3 View

What is the system of units used in the thermal conductivity by Spitzer and Harm?

23 February 2021 9,253 1 View

How many days do we need to detect adoptively transferred Treg in the tumor site in tumor-bearing recipient mice?

Hello, I've got a plan to isolate mouse splenic Treg (WT and KO of target gene) and inject these CD45.2 Treg into tumor-bearing CD45.1 mice. My question is how many days do I need to wait to see...

11 February 2021 8,238 1 View

I have faced a problem to amplify VP2 gene of porcine parvovirus 1,2,3 and 5? Please suggest me how can i solve this problem?

Till now i haven't got any PCR amplified vp2 gene bands on specific annealing temperature and in step up PCR.

08 February 2021 819 4 View

Is it possible to antibody labeling with FITC cause antibody disfuction?

Hello, I studied how much bound my test antibodies to the target antigen using FITC labeling to test antibodies. I tested 3 types of antibodies, the elisa binding affinity and cytotoxicity...

07 February 2021 8,335 2 View

Can you use MTS assay with cells cultured in media containing phenol red?

I am trying to run a cell viability assay with LN229, but these cells are cultured in DMEM which contain phenol red. Is the MTS assay sensitive to the additional of phenol red in the media? If so,...

03 February 2021 9,478 2 View

How to analyze a particular region of my simulation box in GROMACS?

Hi, I am using GROMACS 5.1.4 to simulate water in contact with a surface. I am only interested to calculate some properties of water near the surface. Let's say at a distance of x nm from the...

03 March 2021 9,989 2 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Build an orthogonal box in ASE?

Hello, I was wondering the best way to build an orthogonal box filled with a defined crystal structure in ASE. I know it could be easily done in LAMMPS, but I guess it is also doable in ASE. The...

21 February 2021 5,899 4 View

How to correctly choose the number of solution intervals when preforming harmonic analysis in ANSYS?

Good day, I design the rail-wheel geometry and the harmonic frequency ranges between 20-10kHz with 500Hz solution intervals and the results makes sense. Most of the time on the related literatures...

19 February 2021 3,190 3 View

How to obtain regions around the person bounding boxes(excluded the detected people in scene)?

Hi all. I have a set of coordinates of bounding boxes for AVA Dataset. This dataset is used in action recognition. My goal is to get the areas around the people (people are inside boxes) and do...

13 February 2021 2,538 2 View

How to deal with multidimensional predictor in multiple regression?

I am investigating the influence of Trait Emotional Intelligence(TEI) and Communication styles (specifically Precision and Expressiveness styles) on Academic performance. I am now in a fix as to...

10 February 2021 7,630 3 View

FLIM Signal to noise ratio of a time series - can I use dark frames to measure noise?

I am doing an analysis on some FLIM data in the form of time series image stacks. I need their signal-to-noise ratio. Recording starts several picoseconds before the excitation pulse, so no sample...

08 February 2021 7,169 3 View

How to eliminate noise when using a sensor with instrumentation amplifier and giving it's output to Arduino?

When I am trying to implement a pressure sensor through instrumentation amplifier and then giving it's output to Arduino, I am getting garbage value due to noise, so how to eliminate it.

05 February 2021 8,598 11 View

GROMACS: how do I know how many box images a particular atom has moved from from t=0 to t=N?

In GROMACS how do I know how many box images a particular atom has moved from from t=0 to t=N? LAMMPS, for example, has the option to include image flags in the dump file for x, y, and z. Is there...

30 January 2021 8,929 3 View