Why fet is better chopper than bjt?

07 July 2015 0 2K Report

what are the reason?

Badges
Science topic

More Biswajit Singh's questions See All

Due to channel length modulation current in mosfet increases but is this current less than triode region current?

As MOSFET current depends on the channel length and due to channel length modulation drain current increases . What will be the impact on the device?

06 July 2018 6,037 5 View

Is common mode voltage only depends on resistor mismatch in differential amplifier?

1.how common mode voltage measurement is different for dc and ac application? 2.for differential low voltage(microvolt range ) dc measurement using INA ,do i need to concern about common mode...

10 November 2017 7,976 4 View

Why opamp integrator circuit is not affected by miller capacitance?

If we see the input impedance( Zi )seen looking into the inverting input node of the circuit shows its frequency independent(according to Bode Plot)? how is that possible?

05 June 2017 2,965 18 View

What happens to the operating freq of the design if system is operated high voltages?

and also What happens to the operating freq of the design if system is operated at dessert and snow places?how it affects the system operation?

04 May 2017 2,549 3 View

Why leakage current is a major problem at low voltages?

04 May 2017 220 0 View

Which topology used in low latency adc architecture?

can anybody clarify what is the difference between latency and settling time for any Analog to Digital converter.

31 December 2016 7,890 1 View

What is the Internal behaivor of BJT in saturation??

I'am trying to understand to internal behaivor of BJT when it's in saturation. why the current Ic is highets in saturation?

07 August 2016 4,727 1 View

How stability is related to bandwidth?

what is the reason if bandwidth increases then stability increases and if bandwidth decreases then stability decreases? how transient response is dependent on the bandwidth?

02 March 2016 1,745 13 View

If the gain of open loop system is doubled the gain margin of the system is

1.not affected 2.doubled 3.halved 4.one fourth of original value

06 July 2015 8,660 0 View

Why Vce(sat)=0.2V?

what will happen if resistor is connected in between emitter and ground

06 July 2015 1,445 5 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Does any one can help me choose a reasonable basis set for intermediate metal ions interactions with guanine (i.e Fe2+, Mn2+, Cu2+ and exc.)?

Hello every body Does any one has any idea to help me choose a reasonable basis set for intermediate metal ions (i.e Fe2+, Mn2+, Cu2+ and exc.) interactions with guanine or other DNA organic...

01 March 2021 6,187 2 View

What could be some reasons why unstimulated monocytes are getting activated?

Im doing PBMC isolation -> CD14+ enrichment using magnetic beads -> stimulation setup. My negative control is just cells in cRPMI but they seem to get activated over and over again.

28 February 2021 7,883 3 View

Why does intensity drops as concentration increases?

Is there any reason for decrease in fluorescence emission intensity of HSA,BSA when increase the concentration ?

28 February 2021 3,653 4 View

POlymer+DMSO solution and moisture??

What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?

28 February 2021 6,516 5 View

Should we reduce the standard unit of length to 0.31951540592 meter ?

The reasoning behind this question is to align the ratios of the proton potential in energy per charge to the speed of light in distance per time. As these two dimensions appear to be related,...

27 February 2021 947 7 View

What could be reason for getting such type of graph for complex impedance in case of polymer blend films?

Its effect appears in real part of ac conductivity also. Can anyone suggest any reason behind it?

26 February 2021 3,487 3 View

What might be the reason for obtaining two bands in plant genomic DNA extraction?

I got a thin band and a thick band i guess it would be the genomic DNA and the 260/280 ratio is 3.

21 February 2021 6,523 6 View

Methodological confusions regarding deductive and inductive reasoning, hypothesis and theory test?

Hi Colleagues- What do you think about the following methodological issues: 1. Is it methodologically wrong to formulate quantitative research questionnaire based on inductive reasoning? 2. Is it...

21 February 2021 4,634 6 View

What is the reason film thickness increased?

what is the reason film thickness increased when increased doping concentrations give some reasons The measured film thickness is 156, 282, 394, 548 and 681 nm for 0, 1.5, 2.5, 3.5, and 4.5 wt....

17 February 2021 8,987 5 View