How does SEA software normally number subsystems?

Dear colleagues, What is the common subsystem numbering system in SEA modelling software (i.e. VA One, AutoSEA2)? Cheers, Feng

27 February 2021 7,073 3 View

What is the nutrient requirements for E.coli BL21 CodonPlu RIPL strain growing in M9 medium?

Hello. I want to isotopically label the my protein, and I express it in BL21 RIPL using M9 minimal media. It grows extremely slow. I inoculate the colony from a fresh M9 plate into 5ml M9 medium...

17 February 2021 2,852 2 View

How to remove the species data from rda data frame in R (only remain the sites/samples point)?

Dear everyone, When I using the rda function in r, I met this question. As you can see in the figure, there are a lot of deep blue points which refers to the species. But I would like remain...

15 February 2021 8,982 2 View

How to extract RNA from brown adipose tissue(BAT)?

30 January 2021 6,610 3 View

Do you have experience of second round PCR amplification issue?

When 1st-round PCR amplification was finished , I could get a clear expected band, but the amount was very low, so I cut the band and run second-round PCR with same condition, it didn't work, I...

21 January 2021 888 4 View

How to Extract DNA from dried rhizomes, wood, galls etc. stored for a long time?

Dear Respectable Scientists, I have been trying to extract DNA from above mentioned sources using different CTAB/SDS Buffer Compositions and purifying agents but I am not able to extract DNA from...

12 January 2021 5,899 8 View

Find value of heat transfer coefficient in SI units??

A tube is subjected to air at standard temperature and pressure conditions with velocity 5 m/s. initial temperature of the tube is 980 K and drops to 500 K after interaction with the cool air....

21 December 2020 6,408 3 View

Lyophilization problem related to Bacteria derived Gold Nanoparticles?

Respected Dr Yuri and Rawle We have prepared the bacteria derived gold nanoparticles and for its antibacterial and antioxidant applications we want exact concentration and for that purpose we...

25 November 2020 2,565 3 View

Can someone recommend me a classic book of liquid crystals?

I am currently into liquid crystals and have no related background. Can someone tell me which book is the most instructive one to learn basics of liquid crystals? I am more interested in different...

22 November 2020 4,362 6 View

How to determine additional cycle numbers using qPCR in ATAC-Seq?

I am doing ATAC-Seq with OMNI-ATAC-Seq protocol (Kaestner Lab 2019). I did PCR amplification for 5 cycles of my library. Now I use 5ul of the PCR product to do a qPCR to determine how many...

12 November 2020 3,678 1 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

Could anyone recommend papers that focus on mixed-ethnicity Black-Caribbean/Caucasian adopted children?

Dear All, I have been looking for papers, or books, that focus on the issues surrounding adoption of mixed Black-Caribbean/Caucasian children. I am interested in literature that looks at any...

22 February 2021 8,466 2 View

Should I use Pressure Based Solver or a Density-Based Solver?

Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...

22 February 2021 4,882 3 View

How to simulate 5G Quality of Service characteristics?

For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...

21 February 2021 7,624 3 View

Open Source IoT Simulators supported by Machine Learning?

Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...

21 February 2021 2,333 4 View