my film is not depositing on glass . ( not good adhesion ) when i am depositing CDS from cbd method . Can some one guide me properly how to deposit CdS by CBD method . After number of research paper reading I m not able to get good adhesion on glass. My main purpose is to make sb2se3 /Cds Solar cell
Dear Yogesh,
I have wide experience depositing metal-chalcogenide semiconducting thin films on glass substrates by CBD. In particular, the following paper on CdS fims deposited by CBD published by reseachers from my group can be useful for you:
https://doi.org/10.1016/j.mssp.2021.105839
You can use from window film technique for depositing film on glass.
Window film is a thin laminate film that usually made from polyethylene terephthalate (PET), a thermoplastic polymer resin of the polyester family, due to its clarity, tensile strength, dimensional stability, and ability to accept a variety of surface-applied or embedded treatments.
Window films are generically categorised by their construction components (dyed, pigmented, metallized, ceramic or nano), by their intended use (automotive, marine or architectural), by substrate type (glass or polycarbonate), and/or by their technical performance (privacy, solar control, safety and security).
Window film is normally installed by professional service companies but there are also DIY kits widely available.
Dear Yogesh Singh
This link might be helpful, have a look:
1. https://www.researchgate.net/post/How_to_deposit_CdS_thin-film_on_ITO_glass
2. https://www.sciencedirect.com/science/article/pii/S1815385211000356
3. Article Fabrication and Characterization of CdS Thin Film Synthesize...
4. Article Comparative studies of CdS thin films by chemical bath depos...
Kind Regards
Qamar Ul Islam
- Badges
- Science topic