Which statistical test is more appropriate to test for the relation between categorical data and numerical data?

More Regney Hara's questions See All

Alternate to reflecting strips for tachometer?

The reflective strips are used for optical tachometer (non-contact tachometer) to measure the speed. But some times they would not stick properly, while operating at high speed. So, is there any...

27 February 2023 5,960 0 View

Reynold's number formula for thrust and Journal bearing?

What is the formula for the calculation of Reynold number for the thrust and Journal bearing. In this formula, Re = (ρvD)/μ What is the V(mean velocity) and D (characteristic dimension) for thrust...

06 February 2023 3,411 1 View

Why cavitation occurs in the textured/ grooved hydrodynamic (water lubricated) bearings?

When the proposed water-lubricated textured groove thrust bearing is under high speed, the initial cavitation number will increase, so the cavitation effect should be considered when modelling....

30 August 2021 4,802 4 View

Any help about isolating fibroblasts for primary cell culture, from human skin biopsy?

I need to isolate fibroblasts from a neonatal, in order to culture them. I have some conciderations about the method of isolation (digestion or explantation). Thank you very much in advance.

05 May 2021 3,117 2 View

What would be the effective radius/area to be marked from the instrument while studying the UHI?

For monitoring UHI with test beds at different locations in a city, how much geographical area/radius should be assumed in each location in order to evaluate the influence of various geographical...

02 November 2016 3,376 1 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

If we are using snowball sampling technique, how do we justify the true representativeness of the sample statistically? is there any statistical test?

Are there any statistical methods to justify your sampling technique using SPSS or AMOS?

05 August 2024 9,153 4 View

How to report results of Generalised Linear Mixed Models in a journal article?

Hi everyone, If you have written or come across any papers where Generalised Linear Mixed Models are used to examine intervention (e.g., in mental health) efficacy, could you please share the...

04 August 2024 4,130 4 View

Why 3 replicates for most biological assays? Is it enough to examine the data fits normal distribution?

Just bounced on me. Before statistically analysing significant difference, shouldn't we see if data fits normal distribution first? Is 3 replicates enough to testify the hypothesis of normal...

31 July 2024 8,141 13 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

Can you recommend provider Intermediate laboratory test for hydrocarbon, polyethylene & polypropylene?

Accredited laboratory of JV "Uz-Kor Gas Chemical" LLC (Uzbekistan) is looking for providers to conduct interlaboratory comparison tests on gas chromatographic analysis of hydrocarbons (component...

25 July 2024 8,108 0 View

Is factor analysis with quantitative variables possible?

Good morning, I would like to conduct a factor analysis for my work at the municipal level on a panel datae with variables such as income per capita, unmployement rate, percentage employed in a...

25 July 2024 5,104 4 View

Is a reliability test necessary in my survey on translations?

Dear all, I gave 116 respondents 18 translated sentences and asked them to indicate their levels of acceptance of these translations on a five-point scale. Some translations result from strategies...

24 July 2024 8,245 5 View

How to Select the most suitable machine learning algorithm depending on the characteristics of the given dataset ?

I'm working on a project that involves analyzing a new dataset, and I'm at the stage of selecting the most appropriate machine learning algorithm. The dataset consists of both numerical and...

22 July 2024 6,097 7 View

How do I access .vcf files without an R statistical package?

I am currently working on a mendelian randomization study, and I have downloaded the datasets needed from the ieu opengwas project (mrcieu.ac.uk) in .vcf format. I do not have access to an R...

19 July 2024 2,342 5 View

Babak Jamshidi

Explain more about the nature of data. The number of observations is important. Do you want to find the effect, correlation, or interaction?

Mark Tomlinson

It's very difficult to understand what exactly your data is referring to so it is impossible to answer your question.

Koen Van de Moortel

First of all you need to know what kind of relationship between x and y you expect!