Which parameter has to be tune for recession part in HEC HMS?

More Vikram Kumar's questions See All

How to construct unit hydrograph for gauged watershed using multiple rainfall runoff events?

Dear Experts, As we know that construction of unit hydrograph for a guged locations helps in discharge estimation, especially peak discharge. I am interested to construct the unit hydrograph of...

09 October 2017 6,004 16 View

How to answer about teaching style and teaching philosophy?

07 August 2017 5,262 8 View

Significance of auto-correlation?

07 August 2017 4,051 3 View

Trend Analysis on daily stream flow?

Dear Expert I would like to know, is it feasible to find out the trend in daily stream flow of very short duration (2 years) to understand the hydrological process? What are its applicability? Any...

06 July 2017 3,930 16 View

Is there any open software for sensitivity analysis?

01 February 2017 2,262 2 View

What hydrological inference do get from time domain reflectometer (TDR)?

31 December 2016 8,569 3 View

Rules for writing a good scientific paper?

Dear Expert After a break from writing textbook (Civil Engineering), I have started writing scientific papers so can you advice me how to write good scientific paper for reputed journal? What the...

11 December 2016 8,124 6 View

How do we calculate the aquifer transmissivity using discharge series or hydrograph?

11 December 2016 8,820 2 View

What research problem can be address by observing weekly water level of check dam and well depth ?

Dear Experts I am continuously monitoring water level from 8 different check dams and 3 well in near periphery. I wanted to address any hydrology and water resources research problem, so can you...

11 December 2016 3,227 2 View

How GPS Aided GEO Augmented Navigation (GAGAN) can be used for DEM generation?

07 August 2016 4,993 2 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

What are the harmful effects of these extreme rainfall on the health of newborns? What are the reasons for that?

Extreme rainfall associated with climate change is causing harm to babies in some of the most forgotten places.

01 March 2021 5,647 4 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

Should I use Pressure Based Solver or a Density-Based Solver?

Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...

22 February 2021 4,882 3 View

How to simulate 5G Quality of Service characteristics?

For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...

21 February 2021 7,624 3 View

Vikram Kumar

Thanks Dibakar..I have gone through the added files..but my query is still unsolved...

Martijn J. Booij

Dear Vikram,

In HEC-HMS five methods are included to represent recession/ baseflow as contribution to streamflow. These methods vary from the linear reservoir method to the non-linear Boussinesq method. Depending on the method you are using one or more parameters can be calibrated. For instance for the exponential recession method that will be one parameter k: the exponential decay constant.

Regards,

Martijn

Dear Martjin

Thanks for advising. I am still in doubt over choosing the right method for recession. Is the recession parameter are going to effect the peak value and time to peak or else only effect the recession part.

The recession parameter will mainly influence the recession part of the flood wave, in particular the part where the streamflow is decreasing more gradually (after the inflection point) and not so much the peak value and time to peak.