Thanks.
Dear Hitesh,
I worked a lot on this topic years ago. H20-LiBr is a good choice, though there are some limitations.
You can have a look at the following papers of mine, you can download them from RG:
Conference Proceeding: Small size absorption refrigerators: a comparison among different solutions in solar feeding applications
Francesco Asdrubali, Giorgio Baldinelli
Conference Proceeding: Comparison of two similar solar driven absorption chillers for different values of solar radiations
Francesco Asdrubali, F. Ziegler, J. Albers, Giorgio Baldinelli,Andrea Presciutti, S. Petersen
IIR Conference “Solar Heating and Cooling, Perugia, Italy; 09/2006
Conference Proceeding: Experimental and theoretical investigation of solar driven absorption chillers
F. Ziegler, G. Baldinelli, F.Asdrubali, A. Presciutti
IIR International Conference -Thermophysical Propreties and Transfer Processes of refrigerants; 08/2005
Article: Experimental evaluation of the performances of a H20LiBr absorption refrigerator under different service conditions
F. Asdrubali, S. Grignaffini
International Journal of Refrigeration 01/2005; 28(4):489-497. • 1.79
This book chapter will answer your question...."3.14 - Solar Cooling and Refrigeration Systems"
Reference Module in Earth Systems and Environmental Sciences, from Comprehensive Renewable Energy, Volume 3, 2012, Pages 481-494
G.G. Maidment, A. Paurine
Can we keep , our published research paper in thesis as a chapter and How much self plagiarism is allowed for Ph.D thesis ?
08 September 2017 1,471 25 View
What is best combination of cycle time ( Adsorption/Desorption) , Generator temperature and mass flow rate of heat transfer fluid ( Water) in single bed adsorption chiller?
01 February 2017 7,805 3 View
What is the lowest Delta_P , for capillary tube in refrigeration . Can capillary works under vacuum Condition i.e Condenser Pressure 50 kPa and Evaporator pressure 10 kPa ?
07 August 2016 6,818 8 View
Dear Sir , I am performing an experiment for measurement of Adsorption Capacity of Methanol onto Indian ACF. I couldn't get adsorption and desorption properly. What should be the packing density...
08 September 2014 8,952 2 View
How can you determine constant ( D , W0, a and b ) in DR and DA equation for adsorption kinematics.
01 February 2014 3,474 1 View
Which are the Limitations of Continuous adsorption refrigeration system run by solar energy? What are the main problems for designing and fabrication of this system?
01 February 2014 9,107 4 View
Can you give best quality Activated Carbon Fiber supplier or Manufacture. I am working on Solar Assisted Adsorption Refrigerator, in which ACF is used as a adsorbent.
01 February 2014 2,655 2 View
How can we provide optimized flow rate of heat transfer fluid to adsorber bed in adsorption chiller ?.
01 January 1970 6,136 3 View
The stability of the Solar System is a complex subject that blends the classical framework of Newtonian mechanics with the modern insights provided by General Relativity (GR). Understanding this...
07 August 2024 2,569 1 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
Air moisture harvesting Air water collection devices
06 August 2024 5,473 2 View
Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?
06 August 2024 980 5 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...
04 August 2024 8,894 1 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,537 1 View
I conducted an adsorption experiment of arsenic on soil in the presence of different doses of silicon as competing ions to see the effect of silicon on arsenic adsorption and desorption. I took 5...
03 August 2024 6,500 3 View
For a grid connected BESS (lets say 100 MW/200 MWh system, LFP battery), if we charge the BESS in such a way that whenever we can access power from the solar that will charge the BESS. Hence it...
01 August 2024 9,903 7 View