Hitesh Bhargav

9 Questions 7 Answers 0 Followers

Questions related from Hitesh Bhargav

How much Self Plagiarism allowed for PhD Thesis ?

Can we keep , our published research paper in thesis as a chapter and How much self plagiarism is allowed for Ph.D thesis ?

09 September 2017 1,399 25 View

What are the Optimized parameter for single bed adsorption chiller?

What is best combination of cycle time ( Adsorption/Desorption) , Generator temperature and mass flow rate of heat transfer fluid ( Water) in single bed adsorption chiller?

02 February 2017 7,764 3 View

Minimum Pressure Working Range of Capillary tube in refrigeration?

What is the lowest Delta_P , for capillary tube in refrigeration . Can capillary works under vacuum Condition i.e Condenser Pressure 50 kPa and Evaporator pressure 10 kPa ?

08 August 2016 6,751 8 View

Is anyone familiar with measuring the Adsorption Capacity of Methanol on ACF?

Dear Sir , I am performing an experiment for measurement of Adsorption Capacity of Methanol onto Indian ACF. I couldn't get adsorption and desorption properly. What should be the packing density...

09 September 2014 8,917 2 View

Which method is best for measuring adsorption capacity (x or W) for ACF?

How can you determine constant ( D , W0, a and b ) in DR and DA equation for adsorption kinematics.

02 February 2014 3,431 1 View

Which pair of Adsorbent-Refrigerant is best for solar adsorption refrigeration?

Thanks.

02 February 2014 4,585 2 View

What are the limitations of continuous adsorption refrigeration system?

Which are the Limitations of Continuous adsorption refrigeration system run by solar energy? What are the main problems for designing and fabrication of this system?

02 February 2014 9,073 4 View

What is the best quality ACF for solar adsorption refrigeration?

Can you give best quality Activated Carbon Fiber supplier or Manufacture. I am working on Solar Assisted Adsorption Refrigerator, in which ACF is used as a adsorbent.

02 February 2014 2,613 2 View

What is the flow rate of hot water for desorption and cooling water for absorption to single bed adsorber in Adsorption chiller?

How can we provide optimized flow rate of heat transfer fluid to adsorber bed in adsorption chiller ?.

01 January 1970 6,103 3 View