25 March 2015 1 3K Report

     

i am planning to use NWP model, i have to predict 30 mins to 1 hour wind speed and power. or combination of two models. which software to use. MATLAB or anyother. if any one model built up or helpful link please send me

More Arsalan Zaidi's questions See All
How can i find co author?

I need help for writing a chapter.

15 May 2024 3,963 2 View

Can you help in Linkage Analysis Tool?

Can anyone assist with running the Linkage Analysis Tool 'Easylinkage' or any alternative tool for conducting linkage analysis and calculating LOD scores?

06 April 2024 7,273 2 View

Are there any EPA/WHO trace elements standards in sediment available for Cd, Cu, Fe, Ni, Mn, Pb, Co, Cr, Zn, As?

Any links or table will be appreciable

08 February 2024 1,163 1 View

Can anyone suggest me few articles, where Primary & Secondary data analysis is done with Machine Learning & Deep Learning Models?

Hello, I am looking for articles in which the analysis is done with the Machine Learning Models and Neural Networks. Kindly suggest any such articles published within last 1 or 2 years. Thank...

17 January 2024 9,303 5 View

Can Any Researcher in Atomic and molecular Physics help me find values of first five excited states of Hydrogen molecule in units of electron volts?

First excited state of Hydrogen molecule can be found easily. I need to know 4 more values to compare with my calculations. Thanks.

05 December 2023 2,637 4 View

Phase Grain Contiguity & Bonding Phase Thickness of Powder Composite?

Hi. Can anyone explain to me these terms: 1) Phase grain contiguity 2) Bonding phase thickness Q: Simple explanation on this? How to measure this properties? Software / formula ? How does this...

03 December 2023 4,823 1 View

"Which is better for studying the idea of a startup, BMC or Lean Canevas?

"The advantage between..."BMC and The Lean Canevas...

23 October 2023 8,912 2 View

What occupation adversely affects your fine motor skills?

the causes, effects and solutions of weak fine motor skills due to that occupation/job/habit.

08 October 2023 1,032 3 View

Kegg Network Disease Analysis Pathways?

Literature suggests that potential candidate genes in mastitis, but I couldn't locate few of them in the mastitis pathways within the KEGG database. Should I explore another genes for research, or...

13 September 2023 1,114 0 View

How to solve issue of sink and source in Ansys Q3D?

HI Researchers, I am facing an issue while simulation my Ciruict which is imported from (PCB designer to Ansys Q3D simulation) After assigning all the sources and sinks on the object/face the...

06 September 2023 1,484 0 View

Similar questions and discussions
Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How to develop investments in renewable energy sources?

How to develop investments in renewable energy sources?

08 August 2024 5,112 3 View

In WECS : Gain values for conversion of PMSM rotor speed(rad/s) to p.u. input to wind turbine and Torque(pu) of WT to input of PMSM-Torque (Nm) ?

I am working on developing a MATLAB Simulink model of Wind turbine with PMSG followed by MPPT Boost converter. I have gone through so many literature and videos but I am not finding clear solution...

03 August 2024 888 1 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Is there a database with onshore wind production for the wind farms in Portugal?

I am looking to predict some production for future onshore wind energy production in Portugal, is there any database with info of performances of the existing wind farms in the country? something...

28 July 2024 1,750 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

HAs anyone used TGA to find activation enegy of water evaporation?

I have different polymer solutions and I hypothesize that water molecules are retained based on the water-polymer interactions, so the amount of free water is less to intercat with drug tablet....

28 July 2024 9,545 6 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close