Which is the best Visible Light source for the photocatalytic degradation?

05 May 2016 1 7K Report

LED or Xenon

If you are going to simulate the sunlight irradiation, use Xenon.

If your final goal is the artificial degradation (I mean using a light source other than the sun), you can use LED due to its low energy consumption.

Badges
Science topic

More Abhijit N Kadam's questions See All

How much powder sample is required for XPS analysis?

I am going to characterize powder sample by using XPS

11 December 2014 3,256 12 View

Why do we get an XRD peak shift to an higher angle while preparing Zn doped TiO2?

I have prepared Zn doped TiO2 by microwave assisted method and surprisingly we got XRD shift to higher angle. Further increase the concentration of Zn the intensity of the peak get decreased.

11 December 2014 5,115 3 View

What is role of aging in the synthesis of metal oxides nanoparticles?

role of aging in the synthesis of metal oxide

10 November 2014 8,388 2 View

Controlling for pupil light reflex when analyzing pupil size time course?

I used eye tracking to examine how participants from two different populations (A and B) react to an image. Participants in population A exhibit larger pupil sizes over time, but they also have...

10 August 2024 3,229 0 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

How to Add Missing Water Molecules in Protein-Membrane Simulations?

I have protein-membrane simulations (PDB, PSF, DCD) and have noticed that water molecules near the protein are not visible in the simulations. How can I fix this issue? Is there a way to place the...

04 August 2024 1,200 2 View

The Optimal Experimental Approach for Gene Function Analysis?

What is the most suitable experimental setting to understand the consequences of a particular gene: (1) targeted degradation of the specific transcription factor (TF) of the gene, followed by...

04 August 2024 6,265 1 View

Z-average size from Dynamic Light scattering can it be lower than the original probe size?

Hi everyone, Recently I have been conducting Dynamic Light scattering experiments in a micellar solution at 5 and gel at 37 degrees of Celsius with latex particles of diameter 190-500 nm. While...

01 August 2024 1,168 4 View

Can a Conventional 50W visible LED Lamp Emit UV Light?

I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....

31 July 2024 3,843 7 View

While doing Chronoamperometry, when the light is turned off, why the current is not decreasing sharply?

Here, I have used Ag/AgCl as reference electrode and 0.5M KOH.

29 July 2024 4,538 3 View

Aqua regia not heating up?

I used Aqua regia to clean Au nanoparticles in the used glassware. But for some reasons, it is not heating up upon mixing. The color did change from no color to light orange. The Au NPs on the...

25 July 2024 4,390 0 View

I found the zeta potential of exosomes in DLS and it was -8mv. So is it correct or not ?

What should be the zeta potential of bovine milk exosomes

25 July 2024 7,376 5 View

Comparing Liposome Size: DLS Measurement vs. SEM Observation with Air Drying ?

I have an issue with SEM imaging of liposomes. When measured by DLS, they appear to be around 120 nm, but when using SEM with simple air drying, they appear much larger, around one micrometer.

25 July 2024 3,395 3 View