Hi, am doing a research in application of gasohol mixture in carburetor SI engines, where can I find the modeling of such a fuel system for carburetor
if you are doing only flow modelling through a carburetor then it is straight forward as you just need to take modified density and viscosity of the mixture in your formulation.
Thank you Rakesh sir..
I have transfected SpCas9 plasmid (Not viral transduction but lipofectamine transfection of lentiviral construct with SpCas9+PuroR) in human cancer cell lines, and the cells looked ok until...
13 April 2021 6,518 3 View
Hi all, Does eosin stains collagen in IHCs in typical H&E staining? Please share your thoughts below as comments. Please add a reference if possible (much appreciated). Best, J.
22 May 2020 8,342 2 View
Dear Experts, I am looking forward to apply Statistical Package as part of my Health Technology assessment in terms of Economic analysis. I have been using SPSS from my previous projects but there...
28 September 2017 7,132 3 View
If I wanted to buy alpha-Tubulin lentiviral clones it should be expressing EGFP-alpha tubulin as on transcript/protein not as EGFP separate and tubulin as separate proteins. Does anyone know a...
01 January 2013 2,094 4 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,227 2 View
Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...
28 July 2024 5,771 2 View
Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?
27 July 2024 648 3 View
// interested in the difference between floating events and short circuits.
22 July 2024 6,565 0 View
I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...
22 July 2024 3,490 2 View
Chemical Engineering /Food Engineering
20 July 2024 4,152 4 View
I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...
16 July 2024 3,212 5 View
I want to reduce simulation time in CST for frequency domain solver by upgrading my computer. I already have discrete GPU but it doesn't seem to make any difference at all compared to integreted...
10 July 2024 2,789 4 View