When should monitoring and inspection be done for driver switching transformers?

13 October 2014 1 2K Report

Access driver switching should be performed according to the manufacturer's instructions, but in general terms it can be said of the 70,000 or every 5 years whichever comes first visit driver switching must be done.

More Majid Saeedi's questions See All

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

Why electrical charge on the moving plate increase?

Hi, everyone This figure depicts a simulation of an electrostatic energy harvesting system in COMSOL Multiphysics software. My question is regarding the relationship between the changes in...

19 July 2024 4,694 4 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View

Is it necessary that all element pattern of an adaptive array antenna (null-steering) have exact similar pattern?

Is it necessary that all element's pattern of an adaptive array antenna (null-steering) have exact similar pattern? If it is, What is the consequence of different element pattern in an adaptive array?

08 June 2024 5,201 2 View

How can artificial intelligence enhance personalized learning experiences in education, and what are the potential challenges?

Artificial intelligence (AI) has the potential to revolutionize education by providing personalized learning experiences tailored to individual students' needs. AI-driven systems can analyze...

21 May 2024 2,058 3 View

Satellite remote sensing by PCMODWIN4???

I am designing a software system for ordering satellite imagery in a way that by entering the specifications of the satellite orbit and its optical sensor, as well as the target ground area, it...

21 May 2024 6,519 1 View

I am wondering how to set up Cardiac fibrosis in vitro?

I am wondering how to set up Cardiac fibrosis in vitro. I will appreciate all your comments.

15 April 2024 2,524 1 View

FinFET-10nm Technology File?

Dear Authors and Researchers, I'm looking for predictive technology models (PTM) for FinFET including 10nm. Unfortunately, the following webpages do not work...

14 April 2024 4,390 1 View

Why we have a electrical field inside conductor?

Hi In this simulation, i noticed that i have a electrical field inside a conductor almost in range of e-11. this upper plate is connected to 10volt (DC) and by time dependent study it moves...

13 March 2024 1,669 1 View

Help for "credit risk assessment of projects using machine learning"?

When financing projects, credit risk assessment is one of the most important components of a project risk management system and, therefore, requires special attention.The existing models used by...

11 March 2024 549 0 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

The question is how to use Wavenet transform?

HOW CAN I WRITE A CODE TO USE THE WAVENET TRANSFORM AS A FEATURE EXTRACTION METHOD INSTEAD OF DWT IN MATLAB?

03 August 2024 7,829 0 View

Which test should be used to study association among demographic profile and awarness level?

i have to study the awareness and adoption level of cloud computing in a district of India. i also want to use association among demographic variables like gender, age, education, income etc and...

02 August 2024 2,420 3 View

Some new emerging problems on application of RL for scheduling in IoT networks?

I have seen plenty of existing works on applied Reinforcement Learning (RL) policies for optimized scheduling in IoT networks including Q-learning, DQNs, and the newer ones including PPO for...

01 August 2024 8,754 2 View

Why 3 replicates for most biological assays? Is it enough to examine the data fits normal distribution?

Just bounced on me. Before statistically analysing significant difference, shouldn't we see if data fits normal distribution first? Is 3 replicates enough to testify the hypothesis of normal...

31 July 2024 8,141 13 View

Normality assumption for linear regression is The assumption of normality is whether for residual errors or predictor variavble?

When we conduct linear regression, there are several assumptions. The assumption of normality is whether the residual errors are normally distributed, not whether a predictor is normal?

31 July 2024 6,164 3 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View