What's the practical method to calculate (estimate) low air velocity in pipes to optimize an experimental model for Solar distillation, ( air velocity in pipe was modeled using Matlab).
Use anemometer
Vane type anemometer, pitot tube and very low flow rotameter can be used.
Have a look at this link:
http://inspectapedia.com/aircond/Air_Flow_Rates.php
Anemometer and specially hot wire anemometer would be useful.
Hello, I am looking for Standards discharges of treated wastewater into the receiving environment in the Ontario Region, Canada. I tried several websites, but without success. Standars...
31 December 2018 8,211 4 View
UCLA Putterman Research Group fond that: Sonoluminescence from xenon bubbles in water driven by a sound field with a frequency of 1 MHz. A flash of light is emitted as the implosion reaches 100 nm...
10 November 2016 4,224 7 View
(The best approach to maximize the convergence) this function has a minimum value of 0.05, and a maximum value of 0.99.
31 December 2014 3,731 4 View
Starting an research to use a hybrid ANN-CMS to predicte performances in WWTP. Is there any paper about Monte Carlo Simulation(MCS) used in wastewater treatment plant?
11 December 2014 7,071 0 View
I am building an experimental model for water distillation.
31 December 2013 7,776 1 View
.
31 December 2013 3,901 3 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
How to develop investments in renewable energy sources?
08 August 2024 5,112 3 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
The stability of the Solar System is a complex subject that blends the classical framework of Newtonian mechanics with the modern insights provided by General Relativity (GR). Understanding this...
07 August 2024 2,569 1 View
Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...
06 August 2024 9,986 2 View
Air moisture harvesting Air water collection devices
06 August 2024 5,473 2 View