I want to ask a question, about the loading protocol, which is very important, mostly in literature, 2 types of instrumental assemblie were used, 1) first one is to apply the axial load on the top of column and lateral load as well on column almost at distance 300cm from the lower pin of column.
2) second one is, to apply lateral load on beam,
So my question is which one instrumentation will be best and is the placement of strain gauges will be changed in both cases or will remain same.
Ahsin Mehmood The flexural strength of concrete beams under the third point loading test employs a beam testing machine that allows the load to be applied normally to the loaded surface of the beam. The specimen is tested on its side in relation to the molded position. The bearing supports are centered on the beam.
WF 150x75x5x7 can also be utilized for the ring beam. There are several techniques for strengthening existing building structures in preparation for building extension. Steel jacketing is a conventional approach for strengthening RC structures. The project mentioned in this paper employs the same strategy and has been demonstrated to be successful.
Dear Ahsin Mehmood,
I sugget you see links on the topic.
http://www.casopis-gradjevinar.hr/assets/Uploads/JCE_66_2014_1_3_971_EN.pdf
http://www.iitk.ac.in/ce/test/ComponentSystem_23_2016%20-5.pdf
https://www.sciencedirect.com/topics/engineering/column-joint
https://www.structuremag.org/?p=2594
Article Precast concrete column base with replaceable energy dissipa...
Article Development and testing of precast concrete beam-to-column c...
Best regards
- Badges
- Science topic
- Similar topics
- Analytical Chemistry
- Column