What is the scope of research in modern India ?

I think excluding some specific areas , mostly wastes of money. What you says..?

06 July 2018 9,272 15 View

How to select best journal for publication based on your work?

Suggestion please

03 April 2018 8,239 0 View

What should be the correct wycoff position of O and Ti atoms in Anatase phase TiO2?

03 April 2017 9,537 0 View

Which software is more useful for the fitting of UPS(Ultraviolet Photo electron Spectroscopy) data?

Please suggest me a more reliable software to fitting the UPS (Ultraviolet Photoelectron Spectroscopy) data

02 March 2017 3,094 2 View

How TiO2 nano particle can be embedded into DNA for spectroscopy study?

I want to investigate the spectroscopic change in TiO2 loaded DNA. Can anyone suggest me the experimental method?

02 March 2017 2,034 2 View

Is it possible that when higher atomic radii like Fe3+ is doped into Ti4+ site then shifting is towards higher theta value ?

In my case, i have doped iron into TiO2 (up to 5%)and found that there is a higher theta value shifting in XRD data. Is any case where it occurs? Please if possible suggest me any paper to which I...

01 February 2017 4,765 1 View

Is there any relation between bond length and lattice parameter for Ti-O bond in TiO2 nanocrystals?

I want to calculate Ti-O and Fe-O bond length and hence bond strength for TiO2. Actually, I want to compare the bond energy when Fe is doped into TiO2. I also want to know that what is the...

01 February 2017 8,895 4 View

Is there any free online software to calculate lattice parameter from XRD data?

11 December 2016 9,277 8 View

I wants to do quantitative analysis of mixed phase TiO2 (A + R) sample by full proff software Rietveld refinement?

10 November 2016 9,586 0 View

What are the possible parameters can be obtained from MH data ?

10 November 2016 2,140 0 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

How to define and get results (stresses) for certain points of a model in abaqus, using python? When the size of the model changes?

I want to do a parameter study of a aixsymmetric cylinder in Abaqus. I want to create several jobs where I get the stresses for 3 different points in my model. These points are defined. I wrote a...

01 March 2021 10,078 1 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

Does any one can help me choose a reasonable basis set for intermediate metal ions interactions with guanine (i.e Fe2+, Mn2+, Cu2+ and exc.)?

Hello every body Does any one has any idea to help me choose a reasonable basis set for intermediate metal ions (i.e Fe2+, Mn2+, Cu2+ and exc.) interactions with guanine or other DNA organic...

01 March 2021 6,187 2 View

What could be some reasons why unstimulated monocytes are getting activated?

Im doing PBMC isolation -> CD14+ enrichment using magnetic beads -> stimulation setup. My negative control is just cells in cRPMI but they seem to get activated over and over again.

28 February 2021 7,883 3 View

Why does intensity drops as concentration increases?

Is there any reason for decrease in fluorescence emission intensity of HSA,BSA when increase the concentration ?

28 February 2021 3,653 4 View

POlymer+DMSO solution and moisture??

What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?

28 February 2021 6,516 5 View

Should we reduce the standard unit of length to 0.31951540592 meter ?

The reasoning behind this question is to align the ratios of the proton potential in energy per charge to the speed of light in distance per time. As these two dimensions appear to be related,...

27 February 2021 947 7 View

How can I assign a velocity along one direction to CO2 molecules in a molecular dynamics simulation using GROMACS?

Dear all, I am trying to perform a MD simulation about the interaction between CO2 and a polymer. I create my model, solvate it and perform the NVT and NPT equilibration. Now I am not able to...

26 February 2021 10,014 3 View