What should be the GOF in maud analysis? I cannot fit the curve for sigma less than 2.2. Is my fitting not appropiate??

Ayan Mukherjee @Ayan_Mukherjee5

10 October 2014 0 8K Report

Please tell me the valid range for GOF and also i want to know why it varies

Badges
Science topic

More Ayan Mukherjee's questions See All

What softwares are helpful for analysing optical properties of nanomaterials?

Please give details of the software

04 May 2017 2,073 0 View

What softwares are helpful for analysing optical properties of nanomaterials?

i want details of the software

04 May 2017 2,598 4 View

Please suggest some new material for my future research project? I want to work in nanomaterials in material science department.

It ll be helpful to concentrate for future projects...i want material that will be important for next decade

03 April 2017 5,321 9 View

Why there are differences in calculation of Refractive Index of nanomaterial , when calculated from 2 route, from reflactance and transmittance data?

please give theoretical analysis

03 April 2017 717 2 View

What ligand we should used to bind CNT and iron oxides or vice-versa?

I want to get CNT/Iron Oxide thin film layer by chemical process.

09 October 2016 7,356 2 View

Why metal sulphides thin film acts as a gas sensor??

i want a model or theory related to this

08 September 2015 8,765 2 View

Why does copper doped CdS thin film has relevance importance nowadays?

Please gives theoritical reason and an application.

01 February 2015 3,012 2 View

What is the basic principle of CdS thin film gas sensing property against H2S and LPG gases?

I want chemical reaction also.....

07 August 2014 9,625 1 View

What is the basic principle of CdS thin film gas sensing property against H2S and LPG gases?

Give me the chemical reaction

07 August 2014 8,697 2 View

How can the sensitivity of metal sulphides be increased by doping?

please give the basic chemical reaction of it

07 August 2014 1,641 2 View

Physics: Why do we describe light by referring to its wavelength, but microwaves and radar pulses by referring to their frequency?

In physics, the description of the properties of light generally refers to its wavelength (nm), while in the range of microwaves and radio waves we refer to the frequency of a signal (e.g. kHz or...

03 March 2021 1,682 3 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

12% ledeburitic cold work tool steel, etched for revealing retained austenite, any help for clarifying?

Hello everyone. Given microstructure image belongs to a 12% ledeburitic cold work tool steel (annealed and tempered). The sample was etched with picral (100 mL ethanol and 4 g picric acid). I...

02 March 2021 4,119 3 View