Has anybody worked with the phospho specific eIF6 antibody?

I am looking for phosphospecific eIF6 antibody but unable to find it. Has anybody worked with it? Can you provide details about the supplier?

03 December 2012 2,474 1 View

Which is the most ecofriendly and effective activated agent for the preparation of activated carbon from sewage sludge?

I am going to prepare activated carbon from the waste activated sludge coming out of WWTP. Can you please help me in understanding, which chemical/physical activating agent will be most...

07 February 2021 9,507 5 View

Why in BET surface area becomes zero but when detag ads des, it shows good value around 150-200? For single crystals is it a good data to publish?

For single crystals can I give BET data in the publication if it is coming around 200. And why it shows zero value surface area but after detag ads or des it shows value, and which one I should...

02 December 2020 7,173 1 View

What is the equation used in the calculation of surface area from BET plot?

I want to know the equation that I should use when I calculated the surface area using a plot like this one in the attachment. What are the parameters required for the calculation?

15 October 2020 8,364 6 View

Is K-silicate gel a porous material?

I coated a stone surface with K-siilcate. Apparently, it does noe seal the surface since the water penetrae the stone easily and the absorption coefficient does not change too much. However, the...

05 October 2020 3,435 5 View

Can we use Aluminum sheet as a substrate for thin film and have surface area calculated from BET?

I am to calculate surface area of a thin-film using BET and use the same thin-film for electrochemical analysis. I have chosen aluminum sheets, will there be any issues with BET??

27 September 2020 8,456 4 View

How can I determine the type of my membrane NF or UF?

20 September 2020 5,531 2 View

How do I interpret for the following N2 adsorption-desorption isotherm?

I have an adsorption-desorption isotherm of N2 from a 900oC-char sample in mixture of CO2+H20 at 90% of conversion. However, I am not sure this curve belong to what type of isotherm according to...

19 September 2020 8,868 4 View

Is it possible to measure surface area of the polymer film using BET analysis?

I need to measure the surface area of the polymer film (PTFE, PET, 50 um thickness) with micro/nano roughness on the surface (not porous). Is it possible through BET analysis? What is the best way...

20 August 2020 8,866 6 View

How to find a surface area for a material with isotherm type 3?

Hello everyone I would like to ask a way to evaluate a precise, reliable and accurate surface area of a material. I used a nitrogen adsorption-desorption analysis on my material, a nanocarbon,...

04 August 2020 7,708 8 View

Why Nd-doped PbTe showed much lower BET surface area than Yb-doped PbTe?

Why Nd-doped PbTe showed a much lower BET surface area than Yb-doped PbTe?

20 June 2020 9,793 3 View