What is the time enough to freeze dry phenolic extract by using lyophilizer?

More Oday Hasan Ali Al-Jammaas's questions See All

Please I need a detailed procedure for flavonoids assay in food samples?

14 May 2020 9,069 5 View

Does anyone send me a procedure to determine calcium content in sesame seed oil by titration method only ?

11 December 2019 9,661 1 View

Does anyone tell me how we can work a standard calibration for protein?

The calibration curve of protein is key for protein determination in food products, how to work this calibration... Best regards

25 November 2019 9,731 1 View

Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

The aqueous fraction of the hydroethanolic extract is showing the presence of palmitic acid. What is the mechanism responsible ?

Palmitic acid presence in aqueous fraction

05 August 2024 8,624 4 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

For systematic review data extraction, should I use ITT or PP analysis, and count all randomized participants or only those who completed the study?

I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...

01 August 2024 9,993 3 View

For the moringa oleifera extract using ethanol as the solvent,what is the alternative method to concentrate the extract other than rotary evaporation?

99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified

31 July 2024 5,113 4 View

What are the factors that causes the sample to have higher efficacy at lower concentration?

We conducted an antibacterial study of a plant extract. Varying concentrations of crude extract were subjected to microbroth dilution assay. The result showed that only the lowest concentration of...

31 July 2024 8,666 3 View

What Are the Best Alternatives to the MTT Assay for Assessing Cell Toxicity of Colored Herbal Extracts?

I am currently investigating the cytotoxicity of a series of herbal extracts, and like many studies, I have been using the MTT assay to evaluate cell viability. However, I am encountering a...

31 July 2024 193 4 View

Is the black sediment consider as sand? If not, how can I filter it out?

Hi researchers! I'm working on soil texture analysis, and the end result for sand is doubtful because there is black sediment appearing after drying, as shown in the figure. Is it considered sand?...

30 July 2024 557 2 View

Where to start the Analytical model for Dry sliding wear of metal surface ?

I am doing research on wear mechanism of the additive manufactured metal parts under dry condition. Please share the reference to start the analytical modelling of the wear prediction.

29 July 2024 6,115 0 View

Dhifaf Zeki Popular answer

Thanks for sharing this question

Angham Najah Al-Khafaji

Good question.......

Maher H.S. Al-Mohammad

Until the extract turned to powder

Duduzile Molefe-Khamanga

I would suggest you purchase the Freeze-drying catalogue

Dhifaf Zeki

Mamadou Abdoulaye Konaré

This time depends on the performance of the freeze-dryer used, the volume of the extract and even the ambient temperature @