What is the term "t zero" in the crystallization procedure of MOFs? and how it could be obtained?

Amirhossein Javdani @Amirhossein-Javdani

06 February 2023 1 9K Report

The crystallization procedure has different stages like induction, transition, and crystal growth.

Geoff Pain

Time zero?

More Amirhossein Javdani's questions See All

How "MaxQuant" can recognize my Mass Spectrometry data?

Dear all, I am writing to explain my problem and would greatly appreciate any small hints that might help alleviate my desperation. I am relatively new to proteomics, and our laboratory has an old...

26 June 2024 9,948 10 View

What is the problem with my FT-IR analysis result?

There are two graphs [a] is a multi-wall carbon nanotube and [b] is a carboxylated multi-wall carbon nanotube (functionalized). I think there is a problem with the result, especially with a graph...

13 April 2024 2,623 5 View

Is iodometric method a good method for cu titration at the presence of Fe2+ and Fe3+ in the solution?

I synthesized a solution containing Cu2+ (0.5 g/l), Fe3+ (0.26 g/l) and Fe2+ (0.19 g/l) with hydrated sulphate salts and I followed iodometric method containing Starch solution (1 %wt), Na2S2O3...

12 March 2024 4,335 1 View

Hi. I need to make a superoxide anion solution. Last time i tried adding potassium superoxide in DMSO and i ended up with 1.8mM. how can i improve it?

I added 1mg of KO2 in 2 mL of Dimethyl sulfoxide and sonicate it about 10 minutes.

13 December 2023 1,603 2 View

Real-Time PCR Troubleshooting: Amplicon Identity, Curve Overlap, and Melting Temperature Discrepancies?

I am encountering several issues in my real-time PCR experiments and seeking guidance on troubleshooting: 1. Inconsistent Amplification Curve Overlap: The amplification curves in my real-time...

08 October 2023 4,939 0 View

Who knows that how much water can be saved by solar PV power plant rather than thermal power plant like CHP/CCHP to produce each kWh electricity?

I prefer to get the answer for Italy or the average amount of the European Union with a valid reference. Thanks for your contribution in advance.

21 September 2023 1,247 4 View

How to define an axial element (like enhanced truss element) in DIANA software, which ONLY can transfer axial loads in compression (not tension)?

Hello everyone I'm modeling a steel-reinforced coupling beam in DIANA which is embedded to an adjacent shear wall. I want to model rods in the embedment region, which only transfer axial loads...

17 September 2023 5,640 2 View

How can I download lightcycler 96 software?

How can I download lightcycler 96 software to analyze Rosh system.

11 September 2023 1,289 0 View

Variability in cDNA Synthesis and PCR Results: Impact on Real-Time PCR?

I recently conducted cDNA synthesis followed by conventional PCR for quality assessment. In the course of this experiment, I observed some unexpected results that have raised questions about the...

09 September 2023 1,020 5 View

How to analyze 2d and 3d Crack under Periodic Loading in Abaqus?

Hi, I want to analyze a crack in 2d and 3d and find displacement of the Part Block due to that Crack and loading. My question is as I want to create periodic Sine load applying for several second...

21 July 2023 7,212 0 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

Why Powder XRD is performed after cruhsing a crystal if Single Crystal XRD analysis of the same crystal has been performed already ?

What information we can get from PXRD analysis other than from SCXRD analysis of a crystal ?

30 July 2024 6,261 4 View

Culture fibroblasts with or without FGF2?

I'm new to primary human fibroblast culture and I'm studying aging using cells from old and young donors. Some research groups have used media supplemented with FGF2, so I cultured cells in the...

29 July 2024 3,030 2 View

How to know the b axis of a single crystal?

How to apply magnetic field parallel to b axis of any crystal

29 July 2024 4,083 2 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

What is the difference between coordination polymer, MOFs, MCOFs?

Wherever I have referred, it puts me in a dilemma about the exact differences between these. It would be really helpful if someone can put me out of this trouble.

21 July 2024 3,045 3 View

Is it possible to run the AIMD within a system using virtual crystal approximation (VCA)?

I want to study the thermal properties of a mixed system which is constructed by virtual crystal approximation in VASP. When I try to run the ab initio Molecular Dynamics of this system in VASP, I...

19 July 2024 6,569 3 View

What is the angular difference between two sets of Euler Angles?

Let's say I rotate a hexagonal crystal using Euler angles (φ1, φ2, φ3); and rotate another similar crystal using Euler angles (ψ1, ψ2, ψ3). What would be the angular difference between the final...

17 July 2024 5,582 1 View

How we can make this(as in figure) type of crystal structure (any software)?

I want to make this type of structure. Can anybody recommend the application for this?

15 July 2024 5,864 2 View

How to use stress and displacement results from 1st stationary simulation as initial conditions for 2nd eigenfrequency simulation in COMSOL?

Dear All, I am trying to define the dispersion curves of a periodic unit cell in COMSOL Multiphysics with prescribed displacements. I am using two separate studies: - Study 1: Stationary, with...

13 July 2024 7,855 1 View