Is it possible to measure the available power/energy on a distribution line at any point on the line before getting to the consumer premise meter?

Let us assume a 33/0.415kV or a 11/0.415kV transformer is metered at a distribution substation. There are N number of houses connected to transformer. The houses are located at distances 1

29 February 2020 7,925 3 View

Decrease in FT-IR intensity (absorbance) of polymer reinforced with MMT/CNT concentration?

Dear All, Please what could have caused the peak intensity of polymer reinforced with pristine CNT and modified MMT (CNT/MMT hybrid) to be reducing with increase in the nanohybrid filler...

30 January 2020 6,752 6 View

Measuring the electrical conductivity of Polymer/CNT nanocomposite?

How can I determine electrical resistivity or conductivity of polymer nanocomposite? Several attempts using current or voltage generator has proved abortive as all samples reading same value with...

24 January 2020 9,464 3 View

What is the impact of scientific conference on development?

Development refers to a process of growth which is engendered by research. But there are different ways of reporting results of research activities asides scientific conference. Results could be...

16 October 2018 7,612 3 View

How can I reduce noise on the cyclic voltammogram during measurement?

Hello scholars, Recently, I have been working on AOR. I have obtained interesting results, however, the result is a bit disturbing as it comes with noise in the curve. Below is a picture of such....

17 August 2018 4,827 18 View

How can I specify "CONC" as initial condition for a stress analysis in a concrete section in abaqus

24 April 2017 7,896 2 View

What is the cheapest and easiest way to measure heavy metal and nanoparticles in air samples?

As a means of risk assessment in home or work places, a measurement of dust concentration could give a lot for public health concern, therefore quantifying these contaminants become an easy way to...

28 February 2014 1,139 2 View

For those of us in chemistry, environmental science, civil engineering, industrial chemistry, analytical chemistry, chemical engineering, biotech

For those of us in chemistry, environmental science, civil engineering, industrial chemistry, analytical chemistry, chemical engineering, biotechnology etc this paper might be helpful. Link is...

01 January 1970 9,300 4 View

How to analyze a particular region of my simulation box in GROMACS?

Hi, I am using GROMACS 5.1.4 to simulate water in contact with a surface. I am only interested to calculate some properties of water near the surface. Let's say at a distance of x nm from the...

03 March 2021 9,989 2 View

I have designed reflectarray element and feeding it though Horn Antenna on HFSS. After full wave simulation, I am not getting desired results?

I have designed reflectarray element to generate OAM beams at 5.8GHz and feeding it though Horn Antenna on HFSS. After full wave simulation, i am not getting desired results i.e Radiation pattern...

01 March 2021 9,701 5 View

How to size battery banks?

I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...

28 February 2021 1,638 3 View

Is there a method of determining feed digestibility without the need to re-pellet the feed?

I am aiming to determine the ADC values of a commercial fish feed, but I do not have a steam pelleter or extruder available to me. Ideally, the pellets could be coated with some inert marker....

28 February 2021 7,967 3 View

How to model the battery pack in PSIM or PSCAD?

Hello, I have simulated a single battery cell using Thevenin equivalent circuit. For a battery pack, I have a large number of cells connected in series and parallel connections. Is there any way...

28 February 2021 2,116 1 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

Build an orthogonal box in ASE?

Hello, I was wondering the best way to build an orthogonal box filled with a defined crystal structure in ASE. I know it could be easily done in LAMMPS, but I guess it is also doable in ASE. The...

21 February 2021 5,899 4 View

What is the difference between AC conductivity and DC conductivity? Is AC conductivity = ionic and DC conductivity = electronic?

I am reading papers on batteries and although mostly people have reported ionic conductivity in Scm-1 but some have reported DC conductivity as well I and am confused as to what that is. Any help...

21 February 2021 9,207 6 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View