What is the protocol for electroporation using Amaxa 4D nucleofector for NK cells? What is the efficiency?

10 November 2020 1 7K Report

Anyone has the experience in electroporation using Amaxa 4D nucleofector for Naural Killer cells from PBMC prep? I want to use the cell as source for iPSC generation.

What is the efficiency? Thanks

Reza Hadavi

http://www.lonzabio.jp/catalog/pdf/ri/I425.pdf

good luck

Badges
Science topic

Similar topics
Gels

More Guoqiang Sun's questions See All

Seeking Advice on Viability and Execution of Undergraduate Thesis Topic?

Hello everyone, I am currently developing a thesis proposal and would appreciate your input on its viability and how to effectively carry it out. My proposed topic is: "Does the perceived threat...

10 August 2024 8,992 0 View

To perform transfection with DharmaFECT Duo in AGS cells. Could you tell me what the ideal concentration is to avoid significant cytotoxicity?

I would like to perform transfection with the reagent DharmaFECT Duo (Horizon) on the AGS cell line. Could you please inform me of the optimal concentration to use without causing cytotoxicity in...

03 August 2024 3,851 1 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

What is Random Audit?

HI there, I've came across several articles discuss about random audit an Non random to tax evasion or compliance. Most of the articles is relating about effect of audit (random or non random)...

31 July 2024 5,309 7 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

How to add Cr parameter in autodock?

When I run autogrid4 it says: autogrid4: ERROR: Unknown receptor type: "Cr" -- Add parameters for it to the parameter library first! Look forward to your reply.Thank you so much!

29 July 2024 488 0 View

How we can use lattice-based cryptography for construction of S boxes?

Please suggest basic literature on lattice-based cryptography. A kind response from the cryptographic community will be highly appreciated.

24 July 2024 6,291 4 View

I am working on III-V based tandem solar cells.Can anyone explain that solar cells work under forward or reverse biased conditions?

I want to know that n-doped side of solar cell is connected with positive or negative electrode.

20 July 2024 1,348 2 View

Can it is possible to find the cleaved sequence when a protein cleaved by a heamaglutanin protease (HA/P) by any bioinformatics tools?

Bioinformatics tools like peptide cutter

15 July 2024 6,453 1 View

Hello, does anyone know how I can get coordinates of two specific points on a moving body in Abaqus when applying a vdload subroutine?

Hello I am trying to simulate repulsive force of two permanent magnets in Abaqus. I have implemented Force equations into a vdload subroutine. sensitive parameters are the center to center...

15 July 2024 3,491 0 View

Does anyone have experience electroporating SKOV3 cells with a large plasmid using Neon transfection?

I have been trying to electroporate SKOV3 cells with a large plasmid (11kb) without much success. Any tips?

29 July 2024 3,229 1 View

Why cannot i find my protein on cell surface after antibiotic selection of expressing plasmid?

I cannot confirm cell surface protein expression by flow cytometry even after transfection and antibiotic selection of cells. Does it take long for proteins to express on the cell surface? the...

28 July 2024 3,178 3 View

Regarding solubility of Dorsomorphin in DMSO ?

I'm using Dorsomorphin (C24H25N5O) as one component in dual SMAD inhibition of pluripotent stem cells to differentiate into neurons alongwith SB431542. Now as to solubilizing 10mg SB in DMSO for...

11 July 2024 4,832 0 View

Are these iPSC colonies?

I’m currently reprogramming my fibroblast cells using Simplicon RNA OKSG-cMyc TagRFP Kit and after 13 days, these colony/aggregates started to show up in all of my wells. I have 6 wells, 2 wells...

07 July 2024 9,034 2 View

What are these clumps in my transfected PBMCs?

Hello everyone. I cultured isolated PBMCs in Erythroid Expansion Medium for two weeks and then performed electroporation in my expanded PBMCs in order to reprogram them. The first 24h after the...

22 June 2024 346 4 View

How can I optimize the protocol of pirfenidone loading into the exosomes (sonication or electroporation)?

What parameters are important in this process?

17 June 2024 4,463 0 View

Why is iPSC in bad condition?

I saw the iPSC about a week after holding the stock (12 well and 3 stocks) and there were very few cells attached, and some cells were differentiated. I wonder what the problem is. The plate is...

12 June 2024 6,087 0 View

What's wrong with my iPSC cell morphology?

This shape gradually spreads. Even if you install new cells again, it will change like this at some point. Has anyone experienced the same thing as me? I tried using Matrigel again by aliquot it....

12 June 2024 7,269 5 View

What type of contaminant is it and how to decontaminate?

Hello everyone. I am culturing hIPSC in mTeSR-1 medium. I found some small round white particles persistently attached to cell colonies, and some actively moved under the 40X objective. Also,...

08 June 2024 6,797 5 View

Is it safe to make a glycerol stock from Agrobacterium transformed cells from a 10-day plate?

Hello all. I transformed some Agrobacterium competent cells by electroporation and performed colony PCR to see the positive transformants. However, I performed the glycerol stock after 10 days of...

26 May 2024 9,304 3 View