What is the maximum permissible limit of Zinc, Cu, Al, & Sn in AISI 304, & 321 Austenitic stainless steel?

More Javed Kamran's questions See All

Please inform me about the International Conference on Plant Biology?

Please inform me about the International Conference on Plant Molecular Biology, or Plant Biology, scheduled for December 2024, January/February, or March 2025.

14 July 2024 3,120 7 View

Can zinc oxide (ZnO) effectively purify water, and what are the key mechanisms that make it suitable for water treatment?

I am interested in understanding the effectiveness of zinc oxide (ZnO) for water purification or treatment. I would like to know about its specific mechanisms and applications in addressing water...

14 June 2024 5,389 1 View

What's wrong with my PCR products?

Hi , I have run my PCR products on gel electrophoresis, but I have seen excessive smear , do you have any suggestions for that?

08 June 2024 6,774 7 View

How 9 point stencil is better than a 5 point stencil in polar coordinate system to approximate Laplacian by finite difference method?

Give a concrete example to prove this

06 June 2024 3,630 0 View

How do we check the strength of a mediation hypothesis (calculated by Hayes Process Macro) by "Variance Accounted for Technique"?

11 May 2024 3,044 0 View

Please determine a suitable dimension for a wave channel to fit within a lab space of 16 meters by 5 meters；how about 12 meters long, 0.8 meters wide?

Hello everyone. I need a wave cahnnel for offshore wind turbine design. Can hydraulics experts help me in designing the wave channel with quotations links?

05 May 2024 6,867 2 View

Why electron and hole thermal velocities are same for all materials in scaps simulation, why?

why electron and hole thermal velocities are same for all materials in scaps simulation, why

27 April 2024 2,906 1 View

Do you struggle with low DNA yield after extraction?

Molpure's SorbElut DNA extraction columns tackle the challenge of low yield. We're interested in collaborating – is there a potential fit for your research?

25 March 2024 6,622 0 View

HIV high prevalence in Pakistan. Reasons and under treatment patients ?

HIV uncontrolled in south Punjab and Sindh

04 February 2024 1,891 2 View

I have done miRNA sequencing and there are 464 novel miRNAs. How is it to show novel miRNAs on heat map, volcano plot along with known miRNAs?

I have done miRNA sequencing and there are 464 novel miRNAs. How is it to show novel miRNAs on heat map, volcano plot along with known miRNAs? Secondly, I also want to know how to go ahead with...

01 February 2024 1,383 4 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

How to fix errors in my heat transfer steel structure with reinforced concrete slab model Abaqus?

I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...

07 August 2024 1,028 0 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Will the catalytic effect of retained austenite happens in steels including RA?

The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...

27 July 2024 8,508 0 View

Please investigate the effect of temperature and strain rate of hot deformation and the formation of delta ferrite in martensitic stainless steel 410?

25 July 2024 9,408 0 View