Do you struggle with low DNA yield after extraction?

26 March 2024 0 7K Report

Molpure's SorbElut DNA extraction columns tackle the challenge of low yield. We're interested in collaborating – is there a potential fit for your research?

Badges
Science topic

Similar topics
Chemistry

More Kamran Ghashghaei's questions See All

What's wrong with my PCR products?

Hi , I have run my PCR products on gel electrophoresis, but I have seen excessive smear , do you have any suggestions for that?

08 June 2024 6,773 7 View

Please determine a suitable dimension for a wave channel to fit within a lab space of 16 meters by 5 meters；how about 12 meters long, 0.8 meters wide?

Hello everyone. I need a wave cahnnel for offshore wind turbine design. Can hydraulics experts help me in designing the wave channel with quotations links?

05 May 2024 6,867 2 View

How to prevent preliminary dilation of stress paths in loose sand samples shearing under undrained triaxial soil compression (CU) condition?

We have sheared numerous loose samples of sandy soils in undrained TXC conditions. A common behavior observed herein was dilatancy in stress paths at the first stages of shearing. Normally, it's...

16 December 2023 1,931 1 View

Request for guidance on protonation of ligand in MD simulation in gromacs and generation of correct gro file?

I hope this message finds you well. I am currently working on a research project focused on MD simulation study of drug desorption behavior on a boron nitride nanosheet with a non-covalent polymer...

28 September 2023 4,514 0 View

How to obtain correct topology of a system in which a polymer is covalently functionalized with nanosheet?

I am writing to seek assistance on a matter related to n2t file generation. I am using GROMACS and charmm36 force field in my work. I am covalently attaching a short polymer(poly-peptide) to a...

30 August 2023 8,022 2 View

How to obtain topology of a system in which a polymer is covalently functionalized with nanosheet/nanotube?

Dear research gate community, I am trying to simulate a boron nitride nanosheet covalently functionalized with a short chain polymer using charmm36 force field in gromacs. I obtained the str file...

19 August 2023 6,243 1 View

How to perform MD simulation on boron nitride nanosheet on GROMACS using charmm force field and how to create appropriate.n2t file?

I am reaching out to seek guidance and assistance regarding a challenge I've encountered while attempting to simulate boron nitride nanosheets using the CHARMM force field, specifically CHARMM36....

11 August 2023 7,922 2 View

I am looking for irradiance data of Photovoltaic Integrated Vehicle or Solar Vehicles. Can someone provide with some data?

Hi Guys, I m working on Solar Vehicles or Photovoltaic Integrated Vehicles. I need data of irradiance profiles. If someone has data or has any lead to where I can get it, I'd highly appreciate it.

23 June 2023 7,203 0 View

Has anyone used Script Mode for Programming DDP600-10 DC Power Supply for Programming PV Curves?

Hi All, I'm using DDP600-10 Programmable DC Power Supply by Adaptive Power Systems (APS). I'm using PVSim Mode to program I-V Curves for PV systems and the ultimate goal is to program the I-V...

29 May 2023 7,697 1 View

Do we have a general formulae for getting I-V curve of an array of solar cells under different shading?

Hi, I am trying to come up with general formulae that can be used to get the characteristic curves of an array of PV cells/modules connected in any interconnection scheme. For each scheme, there...

20 March 2023 626 0 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,800 2 View

Is there a problem with my RNA pellet?

Hello, I am currently having problems with RNA extraction. I am using mouse liver (C57BL6J), and I have extracted RNA from mouse liver before. Before this experiment, my final RNA pellets were...

11 August 2024 7,080 3 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,140 3 View

RNA Extraction Using Hot Borate Method No Longer Working?

I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...

08 August 2024 9,881 2 View

Can I use a HisTRAP column for affinity chromatography?

I'm working on selecting antibodies against a recombinant protein that has a His-tag. My idea is to first bind the recombinant protein to a HisTRAP column and then use this column for an affinity...

07 August 2024 503 3 View

Hi, please what is the best tool on Aspen plus that can help me get the best inlet temperature and pressure for cryogenic distillation?

I am trying to recover liquid CO2 from a mixture of 0.6 CO2, 0.3 N2, and 0.1 O2. My aim is to recover about 99% liquid CO2 at the bottom of the column and make sure the amount of gaseous CO2...

06 August 2024 4,609 0 View

Low-yield gel extraction problem?

I am having an issue with my gel image where my PCR product is not appearing very bright on the gel. When I perform gel extraction, the A260/280 purity value is very low. I used the Qiagen gel...

05 August 2024 9,798 3 View

Do you have good tips for seaweed tissue preservation in the field for post RNA extraction?

I will be with my students collecting seaweed samples in a marine farm and later we will process this tissue for RNA isolation and further sequencing. Does anyone have tips on how to collect the...

04 August 2024 500 2 View

The question is how to use Wavenet transform?

HOW CAN I WRITE A CODE TO USE THE WAVENET TRANSFORM AS A FEATURE EXTRACTION METHOD INSTEAD OF DWT IN MATLAB?

03 August 2024 7,827 0 View

How to perform EEG source analysis on each trial of data separately?

Hello Everyone I have a question about structure for connectivity analysis on sources. My goal: preprocess and cut data into trials create headmodels, using template MRI file perform source...

30 July 2024 2,743 1 View