What is the Hansen Solubility parameters for Ni(OH)2 nanosheets?

08 August 2018 0 10K Report

Can anyone please tell me about the hansen solubility parameters of Ni(OH)2 nanosheets? Any reference?

Badges
Science topic

More Sayan Dey's questions See All

How can I increase the response and reduce the recovery time of a sensor prepared by nickel oxide nanostructures?

I am preparing gas sensors with NiO coral like nano structures (in the form of thin films/drop casted on IDE). I am getting good sensitivity for NO gas but the response is poor (around 41%) and...

09 October 2015 2,493 10 View

I want to prepare NiO-ZnO nanostructured junctions using chemical method. Can you suggest me possible synthesis methods to do so?

Both NiO and ZnO should be nanostructures like coral, sphere, rod etc. and the synthesis method should be chemical method.

08 September 2015 6,820 7 View

How can I prepare TiO2 and SnO2 quantum dots?

I want to prepare n-type TiO2 and SnO2 quantum dots. How can I prepare those using low temperature synthesis technique?

08 September 2015 4,371 0 View

How can arsenate ions be spectroscopically quantified in a solution?

I have unknown samples of arsenate (As(V)) ions in water. I want to quantify them using UV/Vis spectroscopy. How can I do that? Please remember that I don't need Arsenite (As(III)), I need only...

01 January 1970 6,406 3 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

Do you kow of any database containing data on retention time, log P and polarizability for a large number of molecules?

Hi, I am a chemistry undergraduate doing my dissertation project on HPLC. In my project, I need to predict the HPLC retention time of 20 aromatic molecules, the calibration set. To do this I will...

24 February 2021 2,602 1 View

How to seperate PEG-4000 from aqueuse phase ?

Hello everyone , Please tell me if It possible to seperat POlyethelyn glycol -4000 from an aqueuse media by other ways rather heating . I have tried salting out by electrolyte solution to...

22 February 2021 7,285 5 View

How to analyse monosaccharide compositions from soluble fiber?

I have tried to hydrolyze the sample using 2 M TFA at 100C for 24, 48 h and 120C for 2 h. From these conditions, the HPLC results showed that peaks were not separated into monosaccharide. I found...

17 February 2021 5,230 1 View

No title

Hello. I ask for help - I need to get lithium tetraborate (soluble salt) from lithium carbonate and boric acid. In literature, everything seems to be simple - mix, ignite and - it's done. But it...

16 February 2021 9,523 2 View

Is There are any idea to achieve H NMR signals for swollen compound ??

the samples are not completely soluble - just swelled the solvents that's mean the sample may be partially soluble any suggestion, please

16 February 2021 8,801 3 View

Which non-coordinating solvent dissolves anhydrous Iron(II)chloride?

Hallo, i am looking for a non coordinating solvent that dissolves anhydrous FeCl2 for a synthesis in which i can not use solvents like thf, pyridin etc.. I already tried benzene (no solubility),...

11 February 2021 6,105 1 View

DMSO concentration in cell culture? Precipitating while PBS is added?

I am testing a compound on RAW 264.7. the compound is soluble in DMSO. but to ensure that final concentration of dmso is not more than 0.1%, we are first dissolving it in dmso and then diluting it...

11 February 2021 1,136 3 View

Solubility of PMP in solvent?

What is the maximum solubility limit of poly(4-methyl-1-pentene) in N,N, dimethylformamide? I gone through solubility parameter concept but I did not get the answer for maximum amount of polymer...

02 February 2021 947 3 View