Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

How can we raise the figure when we writing a paper with Latex ?

Hi, everyone. I'm a starter to write a paper by Latex. But I have some difficulty using it. I'm writing the paper with 2 columns. And, there is one figure that occupies the 2 both-sides. I want to...

26 February 2021 3,738 3 View

Satellite orbit estimation using Recurrent Neural Network - what should I use?

Hello, I am a master's student studying in Yonsei Univeristy, Korea. I am trying to estimate the state of satellite, using Neural Network. Below is a simple flow of my study. 1. Train (t0 ~ t1)...

23 February 2021 6,383 3 View

What is the system of units used in the thermal conductivity by Spitzer and Harm?

23 February 2021 9,253 1 View

How many days do we need to detect adoptively transferred Treg in the tumor site in tumor-bearing recipient mice?

Hello, I've got a plan to isolate mouse splenic Treg (WT and KO of target gene) and inject these CD45.2 Treg into tumor-bearing CD45.1 mice. My question is how many days do I need to wait to see...

11 February 2021 8,238 1 View

Is it possible to antibody labeling with FITC cause antibody disfuction?

Hello, I studied how much bound my test antibodies to the target antigen using FITC labeling to test antibodies. I tested 3 types of antibodies, the elisa binding affinity and cytotoxicity...

07 February 2021 8,335 2 View

Can you use MTS assay with cells cultured in media containing phenol red?

I am trying to run a cell viability assay with LN229, but these cells are cultured in DMEM which contain phenol red. Is the MTS assay sensitive to the additional of phenol red in the media? If so,...

03 February 2021 9,478 2 View

Lighting for open field test behavior assay?

I am currently setting up our lab's behavioral space to run the open field test in rats, and I am trying to figure out how to set up lighting to evenly illuminate the open field chamber (a 90 cm x...

26 January 2021 1,399 3 View

Is there a surface inactive water-soluble dye?

Hi guys, I'm looking for a water-soluble dye which is not surface inactive in order to observe (water in oil) emulsions; I don't prefer to use oil-soluble dyes. I've used rhodamin123,...

21 January 2021 8,496 2 View

Can I calculate the average from the data which are collected every 30 minutes for ANOVA?

I artifically elevated the air temperature in the heated plot by 3-celsius degree compared to that in the control for 7 days. I want to figure out the effect of the temperature manipulation on...

21 January 2021 1,185 8 View

Solution of 2D convection diffusion heat equation using MATLAB ?

This is a polymer heating problem. Polymer enters at around 180C (x=0) in the barrel. Also barrel initial temperature is 180 (t=0). Some heat Is added along whole length of barrel q. We have to...

15 February 2021 3,887 1 View

Defining effective diffusivity in porous zone and non-porous zone?

Hi all, I am working on methanol steam reforming using packed bed for hydrogen generation. I am using FLUENT software for CFD simulation. In reference paper, authors mentioned that effective mass...

10 February 2021 6,104 1 View

How to match the XRD of a compound for which there is no JCPDS file ? Is there any other characterization to claim the synthesis of desired compound?

I have synthesized LiMgF3 using the starting precursors LiF and MgF2 via solid state diffusion method. Now I am looking for some characterization to claim the desired product, as there is no...

09 February 2021 921 3 View

Is it possible to have a diffusion of oxygen from the glass substrate (SiO2) into the absorbent layer during annealing process?

02 February 2021 382 7 View

How do you determine at what concentration of antimicrobial should you subject the pathogen to?

I am making an antimicrobial extract from fungal metabolite but the fungi are not known. So I don't know at what concentration I should subject them to but what I do know I will test them against...

07 January 2021 897 6 View

Has anyone done lab models on the influence of dead-end pores on mass transport in saturated flow?

Groundwater flows through voids and passages that are interconnected within porous media. Some of the pores are referred to as a dead-end pore space within the porous matrix. The presence of...

07 January 2021 3,590 3 View

Any recommendation to calculate time to dominant design emergence?

Any recommendation to calculate time to dominant design emergence?

01 January 2021 3,809 5 View

Are drones following the e-Auto industry technological trajectory or are they following its own?

* Are drones following the e-Auto industry technological trajectory or it is following its own? * Will drones diffuse faster than electrical vehicles? * Will it depend on the application?, What...

29 December 2020 7,379 3 View

How can I apply the eddy_parameter to the other dataset?

I have one DTI dataset, and I've applied two different reconstruction algorithms to it. Thus there were two datasets with the same anatomical structure but varying in sth like the artifacts and...

28 December 2020 2,745 3 View

How best can Agricultural Innovation be structured to ensure adequate uptake and farmers adoption?

Technology adoption rates amongst small-scale farmers in the Global South (e.g. Africa) remain low, even when scientific evidence shows that a particular technology is beneficial.

28 December 2020 4,786 23 View