How to Eliminate cosine error and abbe error in LASER measurement system(for example Rhenishaw XL80)?

I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...

28 February 2021 4,890 3 View

How to measure angle between laser travel path and machine axis in Laser Measurement system?

25 February 2021 1,987 3 View

No title

23 February 2021 4,014 3 View

Is ANSYS Fluent good for simulation of a three phase reactor(stusy of its hydrodynamics or mass transfer...)?

Hello everybody, I would like to simulate a three phase reactor and study its hydrodynamics. I would like to know which type of software is better? I have a good command of ANSYS Fluent and I am...

10 February 2021 4,303 3 View

How to increase bacterial concentration of DNA from Laser capture microdissection samples?

I used laser capture microdissection, selected specific bacteria presented in ethanol-fixed slides. And DNA was extracted by Qiamp mini kit. The problem right now is we have pretty low...

09 February 2021 3,908 2 View

What Research is yet left in the field of Automation and Unemployment?

I have been through a number of journals and Research Papers. I wanted to get an idea as to what new areas are still left to be researched in "Will Automation lead to unemployment or it will lead...

09 February 2021 9,332 4 View

What are the ways to test the knowledge level of agricultural labourer about their day to day work?

what kind of test can I do for testing the level of knowledge about their daily operation?

03 February 2021 7,583 10 View

How to measure cosine, abbe, deadpath errors?

Dear sir, How to measure cosine, abbe, deadpath errors. I know cosine error, abbe error, deadpath error occurs in laser measurement. But how i can identify the cosine error value. Is any separate...

03 February 2021 4,878 4 View

How to apply graphene oxide on an gold electrode?

Dear Fellows, now it is the time to push graphene applications further in terms of easy and low cost production surroundings. Thus I recently dived in the materia and I am facing tons of papers,...

02 February 2021 6,284 2 View

Which method is preferable for cutting the nanocomposites?

Which of the methods like water jet cutting, diamond cutting, laser cutting, etc. is more suitable to cut the carbon nanotubes reinforced epoxy composites into test sample to ensure the clean...

29 January 2021 1,354 5 View