What is structurical , electrinic and optical properties exactlly?

01 January 2018 0 5K Report

I red some paper about quantum espresso code and saw that they worked on structurical , electrinic and optical properties of some materials like MAPbI3 and FAPbI3 and . . . but I dont know whats different between these propertise!

can you explain these for me? and tell some properties for every one?

Badges
Science topic

More Jamshid Laali's questions See All

Is it posible to use normalized optical absorption spectra in solar cell simulation?

hello i want to simulate a solar cell with a new optical absorption spectra intensity that i calculated by DFT. i want to know that can i use the normalized spectra in scaps or other simulation...

09 October 2018 8,811 1 View

Is it possible to calculate the absorbance spectrum with quantum espresso?

hello every body i want determine the optical absorbance spectrum of organic-inorganic perovskite with the help of quantum esspreso code. is it possible? if yes how can I do it? thank a lot

06 July 2018 436 0 View

Is it possible to know band gap from scf calculation output in quantum espresso?

hello every one I want to calculate band gap of some materials but i want to know can i calculate it by just a scf run or i must calculate it by band run after svf in quantum espresso?

05 June 2018 7,615 13 View

What is the order of inserting k-points in quantum espresso for bands calculation input?

hello every one I am working on DFT simulation whit Quantum espresso package. I know that for calculate band structure, we should first run a SCF calculation and then Change a bit scf input to...

04 May 2018 8,115 4 View

Where can I find some structural and electronic properties of for GaP and some others materials?

Im looking for below properties for some materials which are used in solar cells: bandgap (eV) electron affinity (eV) dielectric...

03 April 2018 8,641 1 View

How can I find input data for quantum espresso?

hello everyone I want to simulate some materials like methylammonium and some thing else in quantum espresso but i dont know that how can I find input data like ibrav , nat, atomic...

01 February 2018 6,243 3 View

Is there software to simulate perovskite solar cell and determine its Stability under UV radiation?

I am working on perovskite solar cells UV stability and Im looking for a software which can simulate PSCs to determine its stability. I know some software to determine solar cells...

09 October 2017 403 11 View

Is there any software or othere ways to grad perovskite solar cells stability with computer simulation?

I am looking to effect of different materials on the perovskite solar cells stability under UV_light and I want to simulate UV degration effect upon perovskite solar cells but I dont know how can...

09 October 2017 1,030 3 View

What is the electron affinity of FAPbI3?

hello every one i am looking for electron affinity of FAPbI3 perovskite because i want to simulate a FAPbI3 solar cell. but i cant find the important value of electron affinity in any reference...

01 January 1970 3,865 7 View

I have get this error when i calculated the geometrical optimization for prco3, it takes 12 hours until gives this message in the outputfile?

Fatal error in MPI_Allreduce: Other MPI error, error stack: MPI_Allreduce(1628)......: MPI_Allreduce(sbuf=000002459254A180, rbuf=000002459F86A140, count=4851, MPI_DOUBLE_COMPLEX, MPI_SUM,...

09 August 2024 7,615 1 View

1. If I can quantize the atom using this hyperbolic spiral and classical physics, could nature do the same?

If we map as a continuous motion an ionising electron (beginning its journey at n=1) in an H atom, a specific hyperbolic spiral appears (see animation). When we solve this spiral formula, we find...

07 August 2024 5,343 2 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View

Hello Everyone ! I'm looking for a good journal to publish my manuscript with low publication cost?

I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.

06 August 2024 6,796 3 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

How effective is the Citi Bloc standard basket in enhancing the accuracy and comparability of international construction cost assessments?

Citi BLOC Standard Basket Definitions: A standardized unit representing a fixed basket of construction materials, labor, and equipment costs priced in various cities. Purpose: To create a common...

04 August 2024 8,997 1 View

How to use Density Functional Theory to calculate carrier mobilities of solid system?

Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...

04 August 2024 8,894 1 View

Any idea about 'International Research Journal of commerce , arts and science? Is it a UGC listed journal?

Any idea about 'International Research Journal of commerce , arts and science? Is it a UGC listed journal? Kindly advice

04 August 2024 7,367 3 View

Are authors sowing for scientific Journals to be reaping the benefits? We are charged for publication but we offer free peer review services, why?

As authors and academic writers, we usually prepare our manuscript using our own resources. We submit these manuscripts to scientific Journals for peer review and publication sometimes at a fee....

03 August 2024 7,304 2 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View