How to approach CFD simulation results of a flow past a cylinder?

Hi all, I'm doing a transient simulation of flow past a rectangular cylinder close to the free surface. As far as I'm concerned, the common practice is to discard the initial stages of the...

25 February 2021 1,348 3 View

How to calculate time-averaged fields from Ansys CFX solver?

I would appreciate any comments on the following problem. I need to calculate mean fields (e.g. pressure, velocity and vorticity), for which I activate Trn Stats tab in CFX-Pre. However, what I...

21 February 2021 8,548 7 View

The most suitable turbulent models to predict flow past a floating body?

Hi all, I'm planning to simulate flow past a floating body using CFD method with the main purpose of investigating its stability against hydrodynamic forces. A sketch of the problem is presented...

28 January 2021 5,872 5 View

Stable region for VL model?

29 December 2020 4,125 3 View

How can I fix the capacity curve of two different structure?

I have two frames for nonlinear analysis, one of them is CBFs and one of them is BRBFs ( the generals are the same, only lateral elements are different). When I drew the capacity curve of my...

11 November 2020 10,034 3 View

How to measure the equivalent sand-grain roughness of a sandpaper?

I want to use standard sandpapers of different grit sizes to impart flow resistance to a surface. I am wondering how to convert the roughness of sandpaper to an equivalent sand-grain roughness. Is...

18 October 2020 9,384 3 View

How to calculate transvers current correlation function (MD)?

12 October 2020 4,424 1 View

How can I obtain thermal efficiency in thermal photovoltaic (PVT) systems by CFD (FLUENT) method ?

Hi everyone I have a question about the thermal efficiency of photovoltaic thermal (PVT) system by CFD (FLUENT) method. Why thermal efficiency in the morning with 400 W/m2 radiation is more than...

13 September 2020 2,543 4 View

How to deal with ANSYS Q3D surface mesh generation error?

I am trying to extract the stray inductance of a PCB bus bar using ANSYS Q3D. I tried different types of meshes but every time in the middle of the simulation, this error "Surface Mesh Generation...

10 September 2020 2,060 3 View

How can I improve Reinforcement Learning Agent training?

Hello everyone, I am trying to develop an RL agent for a simple double integrator system. Unfortunately, my agent couldn't find the maximum reward. The attached figure is the average episode...

20 July 2020 6,159 4 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Can we classify HV and LV lines based on line length?

I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...

03 March 2021 4,116 4 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

How to access MSCI KLD Stats and Sustainalytics?

Hello all, I'm currently working on my undergraduate thesis and I'm having difficulties trying to access KLD Stats and Sustainalytics because my campus Airlangga University and apparently other...

02 March 2021 8,525 1 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Do you know any MR image dataset?

I would like to research on MR images (0.5T and 3T). Can you please suggest some websites that I can download dataset including both 0.5T and 3T MR images? Thank you.

02 March 2021 7,735 3 View

Which is better medicine or food in obesity?

Preference in terms of the scientific aspect

28 February 2021 796 2 View

Where can I find public datasets with Covid-19 patient information?

Hi, I'm looking for public datasets that have CT, X-ray information, or medical records for patients with Covid-19. Does anyone have suggestions?

28 February 2021 4,760 3 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

Is there any one who can provide a donation of HPV detection and genotyping kits in exchange collaboration fors?

Warm greetings My name is Ayichew S. and I am doing my Ph.D. in Medical Microbiology (on Human papillomavirus). At this stage, I have almost completed a clinical sample Cervical swabs)...

25 February 2021 1,660 3 View