What flange type is used in Zeiss SEMs?

07 July 2020 0 9K Report

Dear community, do you know whether the vacuum flanges widely used in Zeiss SEMs and FIBs correspond to some standard or not? The picture is attached, the outer diameter is 83 mm.

Badges
Science topic

Similar topics
Books

More Oleksandr Glushko's questions See All

About Fuzzy Trees in Matlab?

thanks for all

02 December 2023 6,239 3 View

Does anybody has LC-MS Vipera berus venom chromatogram?

I am looking for LC-MS spectrum of the common adder Vipera berus with or without identification of individual peaks to compare with my results.

17 August 2023 5,877 1 View

What sources about computer methods and means to improve the efficiency of the Information Security Management System can be read?

Looking for objective performance criteria ISMS

30 January 2022 4,491 4 View

Why do my silicon-supported samples in SEM appear to be contaminated with particulate matter?

Dear all Could you, please, advice on the origin of these particulate contamination that appears to happen solely in the matter-containing region of the epoxy slice? I'm investigating insect...

12 September 2021 7,520 3 View

How to generate electron density map in GSAS II?

I want to generate electron density map after Rietveld refinement in GSAS II software.

10 August 2021 1,723 3 View

I feel I am bit outdated - any news with software calculating species trees from gene trees?

I've run into really strong discrepancy between individual genes topologies. Reasons for it quite well known, but what about solutions?

23 June 2021 4,042 0 View

Why palladium is the best hydrogen absorbant?

What is so special about metallic Pd that it can absorb around 900 times its own volumes of hydrogen? I was searching articles, but I couldn't find an answer to this question. All researchers say...

22 June 2021 3,520 5 View

Interpretation of X-ray reflectivity spectrum?

Dear community, I performed XRR measurements on thin film AuAgSi alloys deposited on Si substrate, please see attached image. For simulation i included 2 nm of SiO2 on top of the substrate and i...

03 February 2021 5,611 2 View

What is the best GIS tool to calculate connectivity score for a point along aquatic network?

Hello, I am looking for a GIS tool (ArcGIS, QGIS, R, etc.) that will calculate a measure of habitat connectivity for nodes along an aquatic (estuarine) network? My dataset is comprised of a...

12 January 2021 6,413 2 View

Why does the Young's modulus of stable beta titanium alloys change during heat treatment?

Stable beta titanium alloys do not change their phase composition during heat treatment. But my experiments have shown that heat treatment (homogenizing annealing and quenching) alters Young's...

15 June 2020 6,822 0 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

1. If I can quantize the atom using this hyperbolic spiral and classical physics, could nature do the same?

If we map as a continuous motion an ionising electron (beginning its journey at n=1) in an H atom, a specific hyperbolic spiral appears (see animation). When we solve this spiral formula, we find...

07 August 2024 5,343 2 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

Weak DAPI staining after immunohistochemistry - how to improve?

After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...

05 August 2024 9,637 2 View

Which distribution type should I use when calculating the average particle size from TEM image? and how to calculate the error ?

average particle size calculation from TEM

04 August 2024 2,921 1 View

Why reactivity isn't increased with more empty spots in valence shell?

If from a geometric perspective the non-halogens, non-noble gases have more empty spots in their valence shell, and the filling/exiting of any of the empty spots in the shell constitutes a...

03 August 2024 4,787 2 View

Why is the molecule's orientation with an electric field affect polarizability?

Why is the molecule's orientation with an electric field affect polarizability? Electrons are diffuse enough to be independent with respect to orientation and effect of electric field on...

03 August 2024 7,843 1 View

Why doesn't chromium 2+ ion use all its d-orbitals to receive lone pairs from six waters in [Cr(H20)6)]3+?

I'm guessing it's because the ligand experiences too much electron repulsion or proton repulsion from the chromium to insert them close to the 3d-orbitals which are close to the metal nucleus. Is...

03 August 2024 1,370 1 View

Is it necessary to covary exogenous constructs in a structural model?

I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...

03 August 2024 6,028 4 View