04 April 2019 1 4K Report

I am trying to understand the SPR graphs. Does low association and dissociation rate means the molecule has a low affinity kinetics for the substrate?

More Ramyani De's questions See All
Does Bromophenol Blue dissolve in water completely?

I am trying to make a 1% bromophenol blue solution by dissolving 100mg of the dye in 10 ml water. However, I am not getting a clear solution. I tried stirring it using a stir bar and also by...

09 February 2020 8,232 3 View

Is transient transfection good for protein expression?

I want to express and purify HCN1 channel protein. Will I get a good protein expression if I transiently transfect HEK cells with my channel expressed in a plasmid? This is all very new to me and...

07 August 2019 5,758 1 View

What is the volume of Strep-Tactin Superflow resin I should be using for protein purification?

I am using IPTG induction to express my protein of interest. At the end of induction and cell lysis, I'll be re-suspending my pellet in 40ml buffer. My protein has a N-terminus Strep-II tag and...

05 June 2019 4,638 3 View

Which is a suitable column to purify protein having a Strep-tag?

I need to purify protein which will be further used for pull-down assay. My protein has a Strep-tag. Can anyone suggest a suitable column which will bind to Strep-tag and will enable purification...

05 June 2019 5,029 4 View

If EF3/4 hands of KChIP is already bound to calcium how can they still be high affinity calcium sensors?

KChIPs belong to the NCS group of proteins and binds to calcium ions using their EF hands. Out of the 4 EF hands EF3 and EF4 are known as high affinity calcium sensors. However, my question is if...

09 October 2018 649 1 View

Similar questions and discussions
What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

How to remove cell debris after tissue dissociation?

I'm facing issues with the tumor dissociation protocol for GBM. I use collagenase/dispase with DNase to dissociate my tumor sample. However, even after incubating it for 60mins, I do not get a...

22 July 2024 412 3 View

Is there a name for this type of function?

Let n∈ℕ, where the function f:A⊆ℝ𝑛→ℝ, 𝐴 is Borel, and (A,d) is a completely seperable space. What is the name of the functions where the graph of f in any (n+1)-dimensional box of A×ℝ is...

17 July 2024 258 1 View

Why is linearity somewhat lost when plotting the Stern-Volmer (SV) graph?

When preparing a graph of fluorophore intensity vs. analyte concentration, the linearity shows an R² of 0.999. However, when plotting the same data as Fo/F vs. analyte concentration, the linearity...

13 July 2024 7,131 0 View

Can you please help me with a cyclic voltammetry?

Hi, I was wondering if you could help. When I take CV in GC electrode with the solution of InCl3 0.01M + citric acid 0.01M + NaCl 0.1M, I get such a graph, how can I correct it so that the...

11 July 2024 5,024 1 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close