If I enter my ongoing research, and if for any reason, I suffer a little delay, how will I be sure that some faster, more experienced researcher doesn't fly with my ideas and publish before I am done?
In that case do not reveal your idea here.
I assure you that I will not fly away if I am included in your any or all projects
Citation to your research my be delayed for about 24hr.
I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...
03 March 2021 8,920 3 View
How to upload pdf of my articles published?
03 March 2021 2,183 3 View
There are some books published in LAP. Shall I add it to the RG?
02 March 2021 2,753 1 View
I want to do a parameter study of a aixsymmetric cylinder in Abaqus. I want to create several jobs where I get the stresses for 3 different points in my model. These points are defined. I wrote a...
01 March 2021 10,078 1 View
Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...
01 March 2021 9,911 3 View
it is published by Juniper
28 February 2021 354 4 View
Dear all I am going to publish my manuscript which is from my thesis in a good H-Index journal but I found them very expensive(I don't have financial support) based on the exchange currency of my...
28 February 2021 7,800 6 View
We have seen some authors use some software to write review paper. As obvious, the study of all published papers concerning our studying field is not possible and these software can help us to...
27 February 2021 6,296 1 View
I want to publish paper in journal but I have figures which have drawn with bio-renders, can I put them in the paper or which other software I can use to draw them?
27 February 2021 8,179 1 View
for all the rheology researchers, my question is, how relevant is a mini slump cone (smaller than a standard 50 cent rheometer). currently based on testing, the thickness of slumped material is...
26 February 2021 3,668 1 View