Hygroscopic liquids
Concentrated sulfuric acid, hydrazine hydrate, ethanolamine, glycerol
http://bfy.tw/Jino
You may check also this RG discussion ― About conc. stability of aq. salt sol. exposed to open atmosphere: https://www.researchgate.net/post/Do_aqueous_solutions_of_strongly_hygroscopic_salts_continue_to_hydrate_over_time
Thank you
how about brassinosteriods. these are hormones
I need to do analysis for following Dye and pigment samples by LCMS . 1]Reactive orange 131 Dye 2]Red 49K 3]Reactive Red 241 4]Yellow 9K
03 April 2019 9,367 5 View
How to transfer i Phone 6 music files to PC using i tunes? Please suggest the steps on win 10 environment.
11 December 2018 5,870 1 View
What health problems does polar region people facing?
11 December 2018 5,941 3 View
What is the best solubility of Pigment Red 170? Please give a refernce.
10 November 2018 3,563 4 View
I wan work on sodium formaldehyde sulfoxylate by HPLC and then Mass Spec If anybody has reference article for it please share. Thank you
10 November 2018 2,856 4 View
How much approx time to take a new drug to come in market from its synthesis to actual use as medicine to the patient
09 October 2018 6,317 0 View
What process is going on while deciding mass accuracy in mass spectrophotometer Instrument?
09 October 2018 2,241 1 View
how expiry date for medicine defined
09 October 2018 8,652 0 View
slimming agent (drugs) realy work without side effect to reduce the body weight
08 September 2018 9,541 1 View
I need calculation for defining LOD, LOQ and liniarity range from Cmax value of drug with suitable example.
08 September 2018 8,652 3 View
I want to cool Natural Gas from 195 Kelvin to 138 Klevin in a heat exchanger by using liquid nitrogen as the coolant medium. When entering the heat exchanger, the liquid nitrogen will have a...
01 March 2021 6,450 5 View
I want to do wettability analysis of hydrocarbon oil (octane)/rock/surfactant solution system. but to do the analysis first I have to make rock surface oil-wet. Since hydrocarbon oil does not have...
27 February 2021 5,383 3 View
20 February 2021 8,202 6 View
Hi everyone We need Fast Green to electroporate plasmid into mice embryos, therefore we simply need it to see some color in the liquid we are electroporating so that electroporation is more...
07 February 2021 1,671 2 View
First of all, whether it is possible to identify the presence of water and its amount on the Silicon substrate by using only FT-IR spectroscopy. Can ATR-FTIR spectroscopy find out the wettability...
03 February 2021 9,085 4 View
I want to simulate the tribological properties of solids, liquids, and fluids, please suggest good software.
02 February 2021 3,947 3 View
I have trouble with exciting wavelengths higher than 460 nm while e.g. ex with 405 nm works. Filtercubes are correc, as I used them with my old xenon lamp before... I work on axiovert200M and with...
25 January 2021 5,201 2 View
I have a ethanol-water 50% extract of mango peel. I purified mangiferin from the extract with filtration and precipitation. so i obtained a low concentrated extract which i want to se the IR...
24 January 2021 8,880 7 View
This transition phenomena of Globular to spray mode as voltage , and especially current is raised, is very commonly known to Manual Metal Arc Welding (MMAW) and Gas-Metal Arc Welding (GMAW)...
20 January 2021 7,984 2 View
I was reading a reference (Reitz-A Photographic Study of Flash Boiling Atomization). In his experiment, his boundary condition is delta p and constant velocity. The liquid injection pressure was...
18 January 2021 842 9 View