Very specifically, what determines the choice between stochastic frontier and DEA in efficiency analysis? Does sample size really matter?

More Benard Wabukala's questions See All

How would you carry out a retrospective study on the prevalence of taenia solium, taenia saginata and echinococcus granulosa at abattoirs?

discuss the study design, the relevant data to be collected, how two animal species i.e. cattle and pigs can be incorporated in one paper for discussion and the most relevant data analysis...

09 October 2023 9,176 4 View

What would be a nutritional regimen that would maximise milk production in the Holstein Friesian cow?

define parameters of high milk yield and the nutritional requirements to achieve the high milk yield.

08 January 2023 7,345 4 View

What are the illustrations and structure of lipids critical to the ABO blood System?

Based on classification of lipids and Basic metabolism of lipids.

29 May 2021 2,061 2 View

Can you help me about an error of my microTOF QIII Bruker?

I have this message error on my mass spectrometer Bruker microTOF QIII : the RF amplitude of funnel 1 is out of range. So I have cleaned the funnel 1without successfull. Thank you for your help.

22 October 2020 622 0 View

Any simple example on Ant colony optimization?

Does anyone have a step by step tutorial illustration the Ant Colony Optimization Algorithm (ACO)?

06 September 2019 8,076 2 View

How can the effect of light reflection from the surface of solar concentrator be mitigated while cooking using the concentrator?

While assessing the cooking performance of solar concentrator, too much light was reflected to our eyes which was very inconveniencing

17 September 2018 4,409 3 View

How do i estimate dose measurement uncertainty in CT dose that are generated on the console

23 June 2017 5,842 4 View

How helicobacter pylori is transmissited in children

mode of transmission of helicobacter pylori

15 May 2017 8,851 1 View

What is the best method for assessing bucky/beam perpendicularity?

What is the best method for assessing X-ray equipment for Bucky/ beam perpendicularity. (Note: Not light/ beam congruence). In other words, how do we test that the X-rays from an X-ray tube hit...

25 July 2016 9,235 4 View

Does anyone know the software for analysing image quality of large CT images?

Which software can be used for analysing image quality of large CT images and how to used it?

18 May 2016 2,698 8 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Which distribution type should I use when calculating the average particle size from TEM image? and how to calculate the error ?

average particle size calculation from TEM

04 August 2024 2,921 1 View

How to calculate effect size of AMCE (Average Marginal Component Effect) in Randomized Conjoint Experiment?

I am following Hainmueller, Hopkins, and Yamamoto's (2014) paper for my randomized conjoint experimental data analysis. The link to the paper is provided below. I received a comment from the...

02 August 2024 4,406 0 View

Would you like to join our meta analysis research team?

I am excited to announce an opportunity for dedicated researchers to join our dynamic team for an ongoing meta-analysis study. If you are passionate about research and have a keen interest in...

01 August 2024 6,737 1 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

After a lot of feature engineering for CTR modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing?

After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?

29 July 2024 4,955 0 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

How to conduct a sensitivity power analysis for Kendall's Tau?

Is there a straightforward way to conduct a sensitivity power analysis for a Kendall's Tau correlation? I was considering using the sensitivity setting and "Correlation: point biserial model" test...

28 July 2024 6,133 8 View

How to estimate sample size for GWAS of continuous and discrete traits? What are the pre-requisites?

Genome-wide association study (GWAS) Continuous traits: eg. Height Discrete traits: eg. Eye color

28 July 2024 286 0 View

What is the best method for removing paraffin from plant samples prepared for microtome?

...

24 July 2024 3,087 3 View

Kabiru Abdullahi Ahmad

Attached below are some article which I think might be helpful to you thank you.

Benard Wabukala

Hello Kabiru:

Thank you very much for the great references! Gives me additional sense of argument.

Romanika Okraszewska

Mayby this article will add somethink new:

https://www.researchgate.net/publication/226974152_DEA_DFA_and_SFA_a_comparison

Article DEA, DFA and SFA: a comparison